Dual-curing, self-adhesive resin cement: influence of the polymerization modes on the degree of conversion and microhardness
Open Access
- 1 June 2010
- journal article
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 13 (2) , 171-176
Abstract
RelyX TM Unicem, dual-curing self-adhesive resin cement, was tested in order to evaluate the degree of conversion (DC) and Vickers microhardness (VMH). The specimens were prepared into 4 groups (GR). For GR1, the specimens were irradiated with 500 mW.cm-2 during 20 seconds while for GR3 the same intensity was used but the irradiation time was 40 seconds. The GR2 followed the same polymerization mode of the GR1 but a ceramic disk was applied as a light barrier. For the last group, only the chemical polymerization was carried out. The DC and VMH were measured immediately after the irradiation time and again after 24 hours. Dual-polymerization (light and chemical polymerization) showed higher DC and VMH than the chemical polymerization (dark cure). The presence of a ceramic disk did not affect the DC but reduced the VMH. Increasing the exposure to light, the DC remained almost constant whereas the VMH raised slightly indicating that the VMH is quite dependent on the incident energy. Additionally, the powder/liquid portions of the cement were also characterized. The TG showed that the solid fraction was constituted of 96% of inorganic matter and 4% of vinyl-silane, a coupling agent. Regarding the liquid part, it was found that 84% was related to the mixture of monomers. The SEM revealed that the size particle of the inorganic fillers were between 400 and 11.000 nm. Factors such as energy density, size and distribution of inorganic fillers and the low effectiveness of the chemical cure contributed to the low values of the DC and VMHKeywords
This publication has 26 references indexed in Scilit:
- Correlation between ceramics translucency and polymerization efficiency through ceramicsDental Materials, 2008
- Effect of curing mode on the polymerization characteristics of dual-cured resin cement systemsJournal of Dentistry, 2008
- Influence of ceramic thickness on mechanical properties and polymer structure of dual-cured resin luting agentsDental Materials, 2008
- Light- and time-dependent polymerization of dual-cured resin luting agent beneath ceramicActa Odontologica Scandinavica, 2008
- Light transmission through porcelainDental Materials, 2007
- Effect of Light‐Curing Method and Cement Activation Mode on Resin Cement Knoop HardnessJournal of Prosthodontics, 2007
- Mechanical Properties of Dual‐Cured Resin Luting Agents for Ceramic RestorationJournal of Prosthodontics, 2007
- Degradation of a dental filling material after high caries challengeMaterials Research, 2004
- Effect of light source and time on the polymerization of resin cement through ceramic veneersJournal of Prosthodontics, 2001
- Correlation between hardness and degree of conversion during the setting reaction of unfilled dental restorative resinsDental Materials, 1985