Experimental study on mechanical property and stone-chip resistance of automotive coatings
Open Access
- 1 January 2022
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 9 (1) , 016402
Abstract
The damage of automotive coatings caused by stone impact is a problem that has attracted great attention from automotive companies and users. In this work, experiments were conducted to investigate the dynamic tensile properties and stone-chip resistance of automotive coatings. Four kinds of paint films and three typical coatings (single-layer electrocoat coating, single-layer primer coating, and multilayered coating) were used. Under dynamic tensile load using split Hopkinson tension bar (SHTB), the engineering stress-strain curves of the paint films at medium and high strain rates (from 50 to 600 s−1) were obtained. Results indicated that the mechanical properties of the paint films exhibited strong nonlinearity and strain-rate correlation. A modified anti-impact tester was used to complete repeatable single impact tests. The effects of some key parameters, i.e., impact velocity, impact angle, and paint film thickness, on the stone-chip resistance of coatings were systematically investigated. The influence of contact type under high-speed impact conditions was investigated as well. The surface morphologies of the coatings after impact were examined by scanning electron microscopy (SEM), and the failure mechanism of the coatings under normal/oblique impact was discussed. In all experiments, the paint films showed brittle fracture behavior.Keywords
Funding Information
- National Key R&D Program of China (2017YFE0117300)
- Science and Technology Planning Project of Guangzhou (201804020065)
- Innovation Group Project of Southern Marine Science and Engineering Guangdong Laboratory (311021013)
This publication has 43 references indexed in Scilit:
- Determination of forces in high speed blanking using FEM and experimentsJournal of Materials Processing Technology, 2013
- An Overview of the Scratch Resistance of Automotive Coatings: Exterior Clearcoats and Polycarbonate HardcoatsCoatings, 2012
- Drop-weight impact tests and finite element modeling of cast acrylic/aluminum platesPolymer Testing, 2009
- Finite element analysis of interface delamination and buckling in thin film systems by wedge indentationEngineering Fracture Mechanics, 2007
- Extracting the elastic and viscoelastic properties of a polymeric film using a sharp indentation relaxation testJournal of Materials Research, 2006
- Finite Element Analysis of Dynamic Damage Behaviors of Multi-Layer Coatings under Transverse ImpactTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 2005
- Studies of water transport behavior and impedance models of epoxy-coated metals in NaCl solution by EISProgress in Organic Coatings, 2004
- Failure behavior of an epoxy matrix under different kinds of static loadingComposites Science and Technology, 2001
- Compressive stress–strain properties of automotive paints over a range of strain rates and temperaturesPolymer, 2000
- Automotive waterborne surfacer with improved stone-chip resistanceProgress in Organic Coatings, 1993