Feasibility Study of Waste Motor Recycling through Manual Dismantling and Hydrometallurgical Process
- 1 December 2013
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 594-595, 990-995
Abstract
Huge amount of waste electrical and electronic equipments (WEEE) or electronic waste (E-waste) has been produced every year in the world. It consists of valuable and hazardous metals that can be reused or extracted to minimize the environmental impact. This study is focusing on the investigation of recycling potential of e-waste through manual dismantling process and leaching test. The leaching test was conducted by changing the initial pH with constant stirring speed, constant water-sample ratio and in open air. The morphological structures of the solid samples were observed by SEM and the liquid residue was analyzed by Atomic Absorption Spectroscopy (AAS). It was found that total time required to dismantle all parts in the waste motor is about 10 minutes and the part that required longest dismantling time was armature windings. The metal elements that were observed are Fe, Mg, Pb and Cr. It was found that the pH of the solution increased with the increasing leaching time. The dissolution of Fe and Pb was high in the early stage of leaching but gradually decreased afterward. The dissolution for Mg and Cr was low throughout the leaching process. It was revealed that the metal elements in e-waste can be dissolved using this method and further investigation to increase the dissolution rate is required to ensure that the method proposed is applicable in industry. However, dissolved concentration of Pb must be controlled to ensure that it follows the permissible amount set under environmental standard.Keywords
This publication has 10 references indexed in Scilit:
- Serial Batch Elution of Electric Arc Furnace Oxidizing Slag Discharged from Normal Steelmaking Process into Fresh WaterTetsu-to-Hagane, 2010
- Serial Batch Elution of Electric Arc Furnace Oxidizing Slag Discharged from Normal Steelmaking Process into Fresh WaterISIJ International, 2010
- Reaction between CO2 and CaO under dry grindingPowder Technology, 2009
- E-waste: An assessment of global production and environmental impactsScience of The Total Environment, 2009
- Contamination by trace elements at e-waste recycling sites in Bangalore, IndiaChemosphere, 2009
- Recovery of high purity precious metals from printed circuit boardsJournal of Hazardous Materials, 2009
- Recovery of high purity copper cathode from printed circuit boards using ammoniacal sulfate or chloride solutionsHydrometallurgy, 2007
- Severe PCDD/F and PBDD/F Pollution in Air around an Electronic Waste Dismantling Area in ChinaEnvironmental Science & Technology, 2007
- Elevated Blood Lead Levels of Children in Guiyu, an Electronic Waste Recycling Town in ChinaEnvironmental Health Perspectives, 2007
- Current status and research on E-waste issues in AsiaJournal of Material Cycles and Waste Management, 2006