Thickness dependent dielectric properties of Sol-gel prepared lead lanthanum titanate films
Authors:
- 1 February 1995
- journal article
- research article
- Published by Taylor & Francis in Integrated Ferroelectrics
- Vol. 7 (1-4) , 161-171
Abstract
A series of lead-lanthanum-titanate films (PLT, Pb0.65La0.28Ti0.96O3) films of differing thickness were prepared on Pt/Ti/SiO2/Si substrates using sol-gel techniques. One to six layer films with a layer thickness of 330 Å/layer were deposited by spin-coating from a partially hydrolyzed metal alkoxide solution. After each layer was applied, the films were annealed using rapid thermal annealing (150°C/sec temperature ramp, 1 minute at 700°C, O2 atmosphere). The films were characterized by X-ray diffraction (XRD), electrical measurement of dielectric constant, dissipation factor and leakage current, and cross-sectional transmission electron microscopy (TEM). For all films, only the perovskite phase of PLT was observed by both XRD and TEM. The films showed a strong [100] orientation on the [111] textured Pt substrates. Electrical measurements determined the dielectric constant at 200 kHz for films 1000 Å thick and thicker to be ∼550. These films had leakage current densities of less than 1×10−7 amp/cm2 at 1 volt. The 1000 Å film has an equivalent oxide thickness of 7.2 Å and a capacitance per unit area of 48 fF/μm2. Films less than 1000 Å thick showed reduced dielectric constants and greatly increased leakage currents. The possible origins for the degradation in electrical properties of very thin films (stress, poorly crystallized interfacial layers, second phases, and electrode interactions) were evaluated using TEM.Keywords
This publication has 5 references indexed in Scilit:
- Preferred Orientations for Sol-Gel Derived Plzt Thin LayersMRS Proceedings, 1993
- Electrical characteristics of ferroelectric PZT thin films for DRAM applicationsIEEE Transactions on Electron Devices, 1992
- Cubic paraelectric (nonferroelectric) perovskite PLT thin films with high permittivity for ULSI DRAMs and decoupling capacitorsIEEE Transactions on Electron Devices, 1992
- Advanced cell structures for dynamic RAMsIEEE Circuits and Devices Magazine, 1989
- Hot‐Pressed (Pb,La)(Zr,Ti)O 3 Ferroelectric Ceramics for Electrooptic ApplicationsJournal of the American Ceramic Society, 1971