Operation optimization and costs analysis of the wet desulfurization system in an ultra‐supercritical coal‐fired power plants
Authors:
- 24 September 2020
- journal article
- research article
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 40 (2)
Abstract
With the increasingly strict requirements on energy saving and environmental protection, the economical, efficient and environment friendly operation of large coal‐fired units are being more and more critical. In light of the technical problems of massive energy consumption and high cost in the operation of the wet desulfurization system in a 1,000 MW ultra‐supercritical boiler, the effects of slurry circulation pump combination, slurry pH and absorption tower liquid level on desulfurization efficiency under different unit loads were tested, and the total operating costs were calculated. The results showed that the power consumption under different conditions could be greatly reduced by changing the combination of slurry circulation pumps. The power cost increases from 1,059.42 to 1,146.99 yuan/hr as the combination of slurry circulation pump changes from AC pump combination to BD pump combination under 1,000 MW, increased by 7.63%. Considering all factors, the combination of BC circulating pump can effectively reduce the power consumption cost and achieve the optimal economical operation under the load of 1,000 and 750 MW. The desulfurization efficiency is in direct proportion to the increase of slurry pH. The optimal pH of slurry under 1,000 MW is in the range of 5.50–5.60, 4.80–4.90 under 750 MW, and 4.50–4.60 under 500 MW. Besides, the absorption tower liquid level has a significant impact on the energy consumption of desulfurization system. With the decrease of the absorption tower liquid level, the power consumption cost of desulfurization system shows a downward trend. To avoid the frequent adjustment of liquid level which may result in safety accidents, the optimal liquid level of absorption tower is maintained at 8.00–9.00 m under different unit loads. The research results can provide significant guidance for the operation optimization and fine management of the desulfurization system of the same type.Keywords
This publication has 14 references indexed in Scilit:
- Evaporation and concentration of desulfurization wastewater with waste heat from coal-fired power plantsEnvironmental Science and Pollution Research, 2019
- Modeling and optimization of wet flue gas desulfurization system based on a hybrid modeling methodJournal of the Air & Waste Management Association, 2019
- Environmental effect of current desulfurization technology on fly dust emission in ChinaRenewable and Sustainable Energy Reviews, 2017
- Employing a step-wise titration method under semi-slow reaction regime for evaluating the reactivity of limestone and dolomite in acidic environmentMinerals Engineering, 2016
- Trend of technology innovation in China's coal-fired electricity industry under resource and environmental constraintsEnergy Policy, 2011
- A model for performance optimization of wet flue gas desulfurization systems of power plantsFuel Processing Technology, 2008
- Equilibrium and Mass Transfer in the Ca2+–SO2–H2O System for the Analysis of the Flue Gas Desulphurization ProcessProcess Safety and Environmental Protection, 2004
- Desulphurization of SO2–N2 mixtures by limestone slurriesChemical Engineering Science, 2002
- Model of the Wet Limestone Flue Gas Desulfurization Process for Cost OptimizationIndustrial & Engineering Chemistry Research, 2001
- Experimental Investigation and Modeling of a Wet Flue Gas Desulfurization Pilot PlantIndustrial & Engineering Chemistry Research, 1998