Abstract
In this paper, various approaches to extend scalability of Hafnium-based dielectrics are reported. Among the three crystal phases of HfO2(monoclinic, cubic and tetragonal), the tetragonal phase has been reported to have the highest dielectric constant. Tetragonal phase stabilization by crystallizing the thin HfO2using a metal capping layer and by adding zirconium is demonstrated. The microstructure, morphology, optical properties and impurities of HfxZr1-xO2dielectrics (for 02is reported. To further boost the dielectric constant of hafnium-based dielectrics, incorporation of TiO2, which has been reported to have high dielectric constant, is explored. HfxZr1-xO2/TiO2bilayer films were fabricated. 30 Å TiO2films were deposited on a 5, 8, 12 or 15 Å HfxZr1-xO2underlayer to determine the minimum thickness needed to maintain good thermal stability with Si substrate. CV and IV results indicated that 12-15 Å is the optimal thickness range for the HfxZr1-xO2underlayer. A dielectric constant as high as 150 for TiO2layer is extracted from TiO2thickness series deposited on12 Å HfxZr1-xO2underlayer. In addition to increasing the k-value of Hafnium-based dielectrics, it is important that the threshold voltage of these high-k devices is low. Here we report the use of thin Al2O3capping layers to modulate PMOS threshold voltages. About 100 mV reduction in threshold voltage is achieved by capping HfO2with a 5Å Al2O3film. Finally, dielectric scaling by modifying the Si/high-k interfacial layer is attempted. Nitrogen incorporation into HfxZr1-xO2is shown to be a simple and effective method to lower the capacitance equivalent thickness (CET) of Hafnium-based dielectrics.

This publication has 11 references indexed in Scilit: