Effect of surface roughness on friction and wear behavior of GCr15 bearing steel under different loads
Authors:
Open Access
- 18 September 2024
- journal article
- research article
- Published by Springer Nature in Surface Science and Technology
- Vol. 2 (1) , 1-13
Abstract
To investigate the effects of surface roughness and load on friction and wear behavior, Si3N4 balls and GCr15 bearing steel were selected as the rotating friction pair. The pin-on-disc wear test was carried out under different loads and surface roughness. The experimental results indicate that as the initial surface roughness of the GCr15 bearing steel specimen and applied load increase, the width and depth of the wear tracks also increase, and the wear resistance performance deteriorates. Correlation dimension D and enclosing radius R were used to characterize the running-in quality during the stabilization wear stage. The higher the correlation dimension and the smaller the enclosing radius, the better the running-in quality. The results show that when the initial surface roughness Rq is 0.009 μm, and the applied load is 40N, the corresponding correlation dimension is the highest, and the enclosing radius is the smallest, indicating the best running quality. Conversely, when the initial surface roughness is 1.192 μm, and the applied load is 20N, the corresponding correlation dimension is the smallest, and the enclosing radius is the largest, indicating the worst running-in quality. The running-in quality is related to the initial surface roughness, with lower initial surface roughness resulting in higher running-in quality. The effect of load on running-in quality is complex due to the complexity of the friction system.Keywords
This publication has 26 references indexed in Scilit:
- Sliding Friction and Wear Properties of GCr15 Steel under Different Lubrication ConditionsJournal of Materials Engineering and Performance, 2022
- Characterization and performance analysis of 3D reconstruction of oil-lubricated Si3N4–GCr15/GCr15–GCr15 friction and wear surfaceJournal of Thermal Analysis and Calorimetry, 2020
- A model for hybrid bearing life with surface and subsurface survivalWear, 2019
- Application of chaos theory to optimize the running-in parameters by using a running-in attractorWear, 2019
- Improved tribological properties of Si3N4/GCr15 sliding pairs with few layer graphene as oil additivesCeramics International, 2017
- Chaotic characteristics and attractor evolution of friction noise during friction processFriction, 2017
- Wear simulation in non-lubricated and mixed lubricated contacts taking into account the microscale roughnessTribology International, 2016
- Influence of flattening of rough surface profiles on the friction behaviour of mixed lubricated contactsTribology International, 2016
- Influence of surface preparation on roughness parameters, friction and wearWear, 2009
- The reconstruction theorem for endomorphismsBulletin of the Brazilian Mathematical Society, New Series, 2002