Anomalies in the Geometric Surface Structure of Shaped Elements Composed of Inconel 718 Alloy
Open Access
Abstract
This paper presents the results of investigation that was performed on shafts composed of Inconel 718. Tests were performed in dry and wet conditions. Cutting parameters, such as feed and depth of cut, were constant. The cutting speed was changed. The investigation was performed for various shaft shapes: cylindrical, taper 30°, taper 45°, and sphere. For that reason, the value of the angle between the machined surface and the cutting edge changed. The lowest values of the roughness parameters, Ra and Rz, were obtained for a larger value of the angle between the machined surface and cutting edge. The investigation showed that cutting speed, machining conditions (dry and wet machining), and the variable angle between the machined surface and the cutting edge influenced the surface roughness. Application of a higher cutting speed resulted in lower roughness values. Lower values of roughness parameters were obtained by wet machining.Keywords
This publication has 34 references indexed in Scilit:
- Assessment of Thread-Cutting Strategies to Enable Damage-Tolerant Surfaces on an Advanced Ni-Based Aerospace SuperalloyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2010
- The analysis of credibility and reproducibility of surface roughness measurement resultsWear, 2010
- Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718International Journal of Machine Tools and Manufacture, 2008
- An investigation of cutting forces and surface damage in high-speed turning of Inconel 718Journal of Materials Processing Technology, 2007
- Cutting forces and wear in dry machining of Inconel 718 with coated carbide toolsWear, 2007
- Prediction of residual stress distribution after turning in turbine disksInternational Journal of Mechanical Sciences, 2006
- Analysis of material response to ultrasonic vibration loading in turning Inconel 718Materials Science and Engineering: A, 2006
- Residual stress and surface roughness when facing age hardened Inconel 718 with CBN and ceramic cutting toolsInternational Journal of Machine Tools and Manufacture, 2004
- The machinability of inconel 718Journal of Materials Processing Technology, 1997
- Surface abuse when machining cast iron (G-17) and nickel-base superalloy (Inconel 718) with ceramic toolsJournal of Materials Processing Technology, 1995