Spray evolution, engine performance, emissions and combustion characterization of Karanja biodiesel fuelled common rail turbocharged direct injection transportation engine
- 28 July 2016
- journal article
- research article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 17 (10) , 1092-1107
Abstract
Internal combustion engine research on alternative fuels has gained momentum because of growing awareness about energy security and environmental issues worldwide. Biodiesel offers an ideal solution to these problems and is an excellent partial replacement to mineral diesel. In this study, Karanja biodiesel blended with mineral diesel has been investigated for macroscopic spray characterization vis-à-vis baseline mineral diesel by varying fuel injection pressures (50, 100 and 150 MPa). Spray developed with relatively narrower spray angle for KB20. Injector needle movement for energizing and real injection durations were also compared for diesel and KB20 at fuel injection pressures of 50, 100 and 150 MPa. Needle movement was slightly higher for KB20 because of its relatively higher viscosity. However, with increasing fuel injection pressure, the difference reduced and showed quite similar results. A 2.2 L common rail direct injection sport utility vehicle EURO-IV diesel engine was used for the experiments. Engine performance, emissions and combustion characteristics of KB20 were compared with baseline mineral diesel at (1) the rated engine speed (2500 r/min) with varying engine loads as well as (2) at the rated load at varying engine speeds (1500–3500 r/min). Brake thermal efficiency of KB20 was lower than mineral diesel. Brake-specific carbon monoxide and carbon dioxide emissions decreased with increasing brake mean effective pressure and showed increasing trend with increasing engine speeds. KB20 showed emission of higher number of particles compared to mineral diesel at all engine operating conditions. Higher oxygen content of biodiesel resulted in shorter ignition delay and slightly higher peak cylinder pressure. KB20 showed relatively longer combustion duration compared to mineral diesel at 2500 r/min engine speed.Keywords
This publication has 35 references indexed in Scilit:
- A statistical investigation of biodiesel effects on regulated exhaust emissions during transient cyclesApplied Energy, 2012
- Characterization of PM10 and PM2.5 source profiles for resuspended road dust collected using mobile sampling methodologyAtmospheric Environment, 2011
- Experimental and analytical study on biodiesel and diesel spray characteristics under ultra-high injection pressureInternational Journal of Heat and Fluid Flow, 2010
- Experimental and numerical analysis of spray-atomization characteristics of biodiesel fuel in various fuel and ambient temperatures conditionsInternational Journal of Heat and Fluid Flow, 2009
- Bio-diesel as an alternative fuel for diesel engines—A reviewRenewable and Sustainable Energy Reviews, 2009
- Effect of Spray and EGR Rate on the Combustion and Emission Characteristics of Biodiesel Fuel in a Compression Ignition EngineEnergy & Fuels, 2009
- Biofuels (alcohols and biodiesel) applications as fuels for internal combustion enginesProgress in Energy and Combustion Science, 2007
- Biodiesel development from high acid value polanga seed oil and performance evaluation in a CI engineFuel, 2007
- Biodiesel Development and Characterization for Use as a Fuel in Compression Ignition EnginesJournal of Engineering for Gas Turbines and Power, 2000
- Engines and nanoparticlesJournal of Aerosol Science, 1998