Use of Single‐Walled Carbon Nanotubes as Reinforcing Fillers in UV‐Curable Epoxy Systems
- 4 August 2008
- journal article
- research article
- Published by Wiley in Macromolecular Materials and Engineering
- Vol. 293 (8) , 708-713
Abstract
CNT were dispersed in an epoxy matrix and cured by means of UV light. An increase on elastic modulus and Tg values was measured by DMTA analysis and attributed to the constraint effect of CNT on polymer chain mobility. Excellent scratch resistant coatings characterized by high critical load, small cracks and high recovery were obtained in the presence of a very low CNT content (0.025 wt.‐%). TEM analysis showed some isolated CNT and some cluster agglomerations of size of about 250 nm. It was shown that it was possible to decrease the surface resistivity of the cured samples by three orders of magnitude in the presence of 0.1 wt.‐% of SWCNT content. magnified imageKeywords
This publication has 15 references indexed in Scilit:
- Antistatic Epoxy Coatings With Carbon Nanotubes Obtained by Cationic PhotopolymerizationMacromolecular Rapid Communications, 2008
- Mechanical Reinforcement of Polymers Using Carbon NanotubesAdvanced Materials, 2006
- Dispersion and alignment of carbon nanotubes in polymer matrix: A reviewMaterials Science and Engineering: R: Reports, 2005
- Nanomechanical characterization of single-walled carbon nanotube reinforced epoxy compositesNanotechnology, 2004
- Toughening high performance ultrahigh molecular weight polyethylene using multiwalled carbon nanotubesPolymer, 2003
- Mechanical and electrical properties of a MWNT/epoxy compositeComposites Science and Technology, 2002
- Processing and characterization of carbon nanotube/poly(styrene-co-butyl acrylate) nanocompositesJournal of Materials Science, 2002
- Carbon Nanotubes--the Route Toward ApplicationsScience, 2002
- Load transfer in carbon nanotube epoxy compositesApplied Physics Letters, 1998
- Helical microtubules of graphitic carbonNature, 1991