Assessing Changes in Elemental Mass as a Result of Chemical Weathering of Granodiorite in a Mediterranean (Hot Summer) Climate
Authors:
- 1 May 2003
- journal article
- Published by Society for Sedimentary Geology in Journal of Sedimentary Research
- Vol. 73 (3) , 434-443
Abstract
In ascending order, relatively unweathered granodiorite, ∼ 1.97 m of friable granodiorite, and ∼ 0.91 m of very coarse loamy sand make up a well developed weathering profile that developed on a Cretaceous granodiorite lying within a Mediterranean (hot summer) climatic belt in the Peninsular Ranges of southern California, U.S.A. Textural, modal, and chemical data indicate that in the friable granodiorite and in the very coarse loamy sand, plagioclase was leached at a rate faster than was K-feldspar while quartz remained little changed. In addition, molecular Ca and Na were probably leached at a faster rate from plagioclase and titanite than K was leached from K-feldspar and biotite. Mass-balance calculations show that ∼ 3.4% (± 2.0%) of the original bulk mass of the friable granodiorite was removed during its development. This loss of bulk mass was accommodated through the removal of ∼ 4%, ∼ 9%, ∼ 18%, ∼ 11%, ∼ 17%, ∼ 29%, and ∼ 14% of the masses of Si, Ca, K, Na, P, Ba, and Sr respectively. In addition, the masses of Fe and Y were increased by ∼ 12% and 52% respectively. Of the ∼ 3.4% loss of original bulk mass, ∼ 99% is due to the loss of Si, Ca, K, and Na mass. The severity of chemical alteration is greatest in samples analyzed from very coarse loamy sand. This conclusion is supported not only by textural relationships, but also by mass balance relationships that show that ∼ 11.2% (± 2.1%) of the original bulk mass of the very coarse loamy sand was removed during its development. This loss in mass was accommodated through the removal of ∼ 12%, ∼ 12%, ∼ 42%, ∼ 14%, ∼ 41%, ∼ 80%, ∼ 21%, ∼ 14%, ∼ 10%, and ∼ 40% of the masses of Si, Mn, Ca, K, Na, P, Ba, Zn, Rb, and Sr, respectively. In contrast, during development of the very coarse loamy sand the masses of Ti and Fe were increased by ∼ 17% and ∼ 22%, respectively. Of the ∼ 11.2% loss of original bulk mass, ∼ 99% is attributable to the removal of Si, Ca, K, and Na mass. Data summarized above, and in work by others, imply that plutoniclastic sediment derived from sources lying within a wide range of climatic conditions, do not reflect directly the bedrock from which they were derived, but instead will mirror the compositions of the weathering profile.Keywords
This publication has 29 references indexed in Scilit:
- Dissolution kinetics of quartz in sodium chloride solutions: Analysis of existing data and a rate model for 25°CGeochimica et Cosmochimica Acta, 1992
- Quantifying and testing differences among means of compositional data suitesMathematical Geology, 1990
- The effect of oxalate on the dissolution rates of oligoclase and tremoliteGeochimica et Cosmochimica Acta, 1987
- Reaction rate-surface area relationships during the early stages of weathering. II. Data on eight additional feldsparsGeochimica et Cosmochimica Acta, 1987
- Constitutive mass balance relations between chemical composition, volume, density, porosity, and strain in metasomatic hydrochemical systems: Results on weathering and pedogenesisGeochimica et Cosmochimica Acta, 1987
- Reaction rate-surface area relationships during the early stages of weathering—I. Initial observationsGeochimica et Cosmochimica Acta, 1985
- Prediction of some weathering trends of plutonic and volcanic rocks based on thermodynamic and kinetic considerationsGeochimica et Cosmochimica Acta, 1984
- Chemical processes affecting alkalis and alkaline earths during continental weatheringGeochimica et Cosmochimica Acta, 1980
- The dissolution kinetics of feldspars at 25°C and 1 atm CO2 partial pressureGeochimica et Cosmochimica Acta, 1976
- Pedogenic weathering of tonalite in southern CaliforniaGeoderma, 1970