Relationships between tissue properties and operational parameters of a dental handpiece during simulated cavity preparation
Authors:
Open Access
- 1 January 2013
- journal article
- Published by Portico in Journal of Dental Biomechanics
- Vol. 4
Abstract
A preliminary study was conducted on the development of an intelligent dental handpiece with functionality to detect subtle changes in mechanical properties of tooth tissue during milling. Such equipment would be able to adopt changes in cutting parameters and make real-time measurements to avoid tooth tissue damage caused by overexertion and overextension of the cutting tool. A modified dental handpiece, instrumented with strain gauges, microphone, displacement sensor, and air pressure sensor, was mounted to a linear movement table and used to mill three to four cavities in >50 bovine teeth. Extracted sound frequency and density were analyzed along with force, air pressure, and displacement for correlations and trends. Experimental results showed a high correlation (coefficient close to 0.7) between the feed force, the rotational frequency, and the averaged gray scale. These results could form the basis of a feedback control system to improve the safety of dental cutting procedures. This article is written in memory of Dr Hongyan Sun, who passed away in 2011 at a young age of 37.Keywords
This publication has 20 references indexed in Scilit:
- The dentin–enamel junction and the fracture of human teethNature Materials, 2005
- Cutting efficiency of air-turbine burs on cast titanium and dental casting alloysDental Materials, 2000
- High and low torque handpieces: cutting dynamics, enamel cracking and tooth temperatureBritish Dental Journal, 2000
- Evaluation of bone strength: Correlation between measurements of bone mineral density and drilling forceProceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 2000
- Torque, power and efficiency characterization of dental air turbine handpiecesJournal of Dentistry, 1999
- Comparison of Rotational Speeds and Torque Properties between Air-bearing and Ball-bearing Air-turbine HandpiecesDental Materials Journal, 1989
- Effect of four anticorrosive dips on the cutting efficiency of dental carbide bursThe Journal of the American Dental Association, 1987
- The cleaning of dental diamond bursBritish Dental Journal, 1983
- Fundamental design factors in rotary dental instrumentationJournal of Dentistry, 1980
- Ten high-speed handpieces: evaluation of performance.1979