An efficient decal transfer method using a roll-press to fabricate membrane electrode assemblies for direct methanol fuel cells
Authors:
- Asad MehmoodAMAsad Mehmood
- Heung Yong HaHHHeung Yong Ha
- 1 December 2012
- journal article
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 37 (23) , 18463-18470
Abstract
No abstract availableFunding Information
- Korea Carbon Capture and Sequestration R and D Center
- Ministry of Knowledge Economy
- Ministry of Education, Science and Technology (2012-0008931)
- Korea Institute of Energy Technology Evaluation and Planning (2011-30300-30010)
This publication has 23 references indexed in Scilit:
- Fabrication of catalyst-coated membrane by modified decal transfer techniqueElectrochemistry Communications, 2010
- Fabrication and evaluation of membrane electrode assemblies by low-temperature decal methods for direct methanol fuel cellsJournal of Power Sources, 2009
- Highly sulfonated poly(aryl ether ketone) block coplymers having a cross-linking structureJournal of Membrane Science, 2007
- Performance of direct methanol fuel cells prepared by hot-pressed MEA and catalyst-coated membrane (CCM)Electrochimica Acta, 2007
- A review of anode catalysis in the direct methanol fuel cellJournal of Power Sources, 2006
- Direct methanol fuel cells: The effect of electrode fabrication procedure on MEAs structural properties and cell performanceJournal of Power Sources, 2005
- Development of nanophase CeO2-Pt/C cathode catalyst for direct methanol fuel cellJournal of Power Sources, 2005
- Porosimetry of MEAs Made by “Thin Film Decal” Method and Its Effect on Performance of PEFCsJournal of the Electrochemical Society, 2004
- Ionomer Segregation in Composite MEAs and Its Effect on Polymer Electrolyte Fuel Cell PerformanceJournal of the Electrochemical Society, 2004
- Influence of electrode structure on the performance of a direct methanol fuel cellJournal of Power Sources, 2002