Influence of process parameters and post-molding condition on shrinkage and warpage of injection-molded plastic parts with complex geometry
- 13 July 2023
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 128 (1-2) , 479-490
Abstract
No abstract availableKeywords
Funding Information
- Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (Finance Code 001)
- FAPERGS (2019/766-18460-4)
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (308567/2018)
This publication has 40 references indexed in Scilit:
- Quality control using a multivariate injection molding sensorThe International Journal of Advanced Manufacturing Technology, 2015
- Optimization of processing parameters for minimizing warpage of large thin-walled parts in whole stages of injection moldingChinese Journal of Polymer Science, 2014
- Residual stresses in injection molded productsJournal of Materials Science, 2014
- Effect of gate size on the melt filling behavior and residual stress of injection molded partsMaterials & Design (1980-2015), 2014
- Research on the reduction of sink mark and warpage of the molded part in rapid heat cycle molding processMaterials & Design (1980-2015), 2013
- On the relationship between cooling setup and warpage in injection moldingMeasurement, 2012
- Structure and property of injection‐molded polypropylene along the flow directionPolymer Engineering & Science, 2009
- Minimization of warpage and sink index in injection-molded thermoplastic parts using Taguchi optimization methodMaterials & Design (1980-2015), 2006
- Measurement of residual stress in engineering plastics using the hole-drilling techniquePolymer Testing, 2003
- Residual stress. Part 1 – Measurement techniquesMaterials Science and Technology, 2001