Combustion analysis and cycle-by-cycle variations in spark ignition engine combustion Part 2: A new parameter for completeness of combustion and its use in modelling cycle-by-cycle variations in combustion
Authors:
- 1 June 1998
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 212 (6) , 507-523
Abstract
This paper investigates a technique of calculating the completeness of combustion on a cycle- by-cycle basis. The technique introduces the normalized pressure rise due to the combustion parameter, ψ to describe the completeness of combustion. This parameter is based on the Rassweiler-Withrow method of calculating the mass fraction burned and is derived from the pressure-crank angle record of the engine. Experimental data were obtained from a Rover K4 optical access engine and analysed with a combustion analysis package. A computer simulation was then used to model the data on a cycle-by-cycle basis, both with and without the completeness of combustion parameter. The paper discusses the conditions under which it is suitable to model mean engine cycles, compared with the need to model cycle-by-cycle variability, and comments on the situations in which each type of modelling would be most appropriate. The engine simulation model is also used to investigate cycle-by-cycle variability of NO emissions that have recently been obtained experimentally. The successful aspects of this investigation are that the cycle-by-cycle variability in the completeness of combustion can be determined by use of the parameter ψ, that the inclusion of the completeness of combustion parameter improves the simulation's ability to model the experimental data both in a statistical sense (the coefficient of variation of the indicated mean effective pressure) and on a cycle-by-cycle basis and that cycle-by-cycle NO modelling results are found to compare well with experiment.Keywords
This publication has 17 references indexed in Scilit:
- Modeling of nitric oxide formation in spark ignition engines with a multizone burned gasCombustion and Flame, 1995
- Introduction to Internal Combustion Engines1992
- A Suggestion for Using Powerful and Informative Tests of NormalityThe American Statistician, 1990
- Cycle-to-Cycle IMEP Fluctuations in a Stoichiometrically-Fueled S.I. Engine at Low Speed and LoadSAE International Journal of Advances and Current Practices in Mobility, 1990
- Improving the Determination of Mass Fraction BurntSAE International Journal of Advances and Current Practices in Mobility, 1990
- Comparison of Methods for the Calculation of Mass Fraction Burnt from Engine Pressure—Time DiagramsProceedings of the Institution of Mechanical Engineers, Part D: Transport Engineering, 1987
- Algorithm AS 192: Approximate Percentage Points Using Pearson CurvesJournal of the Royal Statistical Society Series C: Applied Statistics, 1983
- Cyclic Dispersion in the Homogeneous-Charge Spark-Ignition Engine—A Literature SurveySAE International Journal of Advances and Current Practices in Mobility, 1981
- Motion Pictures of Engine Flames Correlated with Pressure CardsSAE International Journal of Advances and Current Practices in Mobility, 1938
- X. Contributions to the mathematical theory of evolution.—II. Skew variation in homogeneous materialPhilosophical Transactions of the Royal Society of London. (A.), 1895