Estimation of the complete stress tensor to 8 km depth in the KTB scientific drill holes: Implications for crustal strength
Authors:
- M. BrudyMBM. Brudy
- M. D. ZobackMZM. D. Zoback
- K. FuchsKFK. Fuchs
- F. RummelFRF. Rummel
- J. BaumgärtnerJBJ. Baumgärtner
Open Access
- 10 August 1997
- journal article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 102 (B8) , 18453-18475
Abstract
For many years, in situ stress in the brittle crust has been measured at relatively shallow depth and related to the mechanical behavior of the crust as inferred from laboratory studies and faulting theory. A continuous profile of the magnitudes and orientations of the three principal stresses has been estimated to depths of 7.7 km and 8.6 km in the German Continental Deep Drilling Program (KTB). This was achieved by hydraulic fracturing tests at relatively shallow depth (1–3 km), estimates of the magnitude of the least horizontal principal stress provided by modified hydraulic fracturing experiments at 6 km and 9 km depths, and analysis of compressional (breakouts) and tensile (drilling‐induced tensile wall fractures) failures of the borehole wall over nearly the entire depth of the KTB borehole. The orientation of the maximum horizontal principal stress was found to be uniform with depth with an orientation of N160°±10°E, which is consistent with the average orientation found throughout western Europe. The only significant change in stress orientation was observed directly below a major fault zone crosscutting the borehole. The profile of stress magnitudes we have obtained demonstrates that to a depth of 8 km, the state of stress in the brittle crust in southern Germany is in frictional equilibrium. That is, the ratio of shear to normal stress as resolved on preexisting faults which are well‐oriented to the in situ stress field is comparable to their frictional strength based on predictions of Coulomb faulting theory for a coefficient of friction of about 0.7 and near‐hydrostatic pore pressure.Keywords
This publication has 52 references indexed in Scilit:
- The German Continental Deep Drilling Program KTB: Overview and major resultsJournal of Geophysical Research, 1997
- Origin and nature of crystal reflections: Results from integrated seismic measurements at the KTB superdeep drilling siteJournal of Geophysical Research, 1997
- The thermal regime of the crystalline continental crust: Implications from the KTBJournal of Geophysical Research, 1997
- The permeable crust: Geohydraulic properties down to 9101 m depthJournal of Geophysical Research, 1997
- Injection‐induced earthquakes and crustal stress at 9 km depth at the KTB deep drilling site, GermanyJournal of Geophysical Research, 1997
- Compressive and tensile failure of inclined well bores and determination of in situ stress and rock strengthJournal of Geophysical Research, 1995
- Stress perturbations associated with active faults penetrated by boreholes: Possible evidence for near‐complete stress drop and a new technique for stress magnitude measurementJournal of Geophysical Research, 1994
- Estimation of in situ stresses by evaluation of time-dependent strain recovery of KTB drill coresTectonophysics, 1990
- In‐situ stress orientation and magnitude at the Fenton Geothermal Site, New Mexico, determined from wellbore breakoutsGeophysical Research Letters, 1988
- Effect of the triaxial stress system on the failure of dolomite and limestoneTectonophysics, 1971