Biodegradable Composites from Pinewood Sawdust and Polyvinyl Alcohol Adhesives
Authors:
- 1 July 2011
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 281, 59-63
Abstract
The objective of this study was to characterize the tensile strength (TS), tensile modulus of elasticity (TM) and shore hardness (HA) of biodegradable pinewood sawdust (PWS)/polyvinyl alcohol (PVA) composites as affected by press temperature, starch/PVA ratio and press time. PWS/PVA composites were prepared by hot press molding under different conditions. The results showed that the TS and TM values of the composite particleboard with press temperature of 140°C were greater than those of the composite particleboard with press temperature of 120, 160 and 180°C. HA decreased with the increase of press temperature. Effect of press time shows the similar trend as the press temperature. The composite particleboard pressed with 10 and 12 min possess the highest TS and TM respectively. when starch/PVA ratio increased from 0 to 17%, 33% and 50%, the TS and HA decreased, however, the tensile modulus increased because elongation at break of composite particleboard significantly decreased when starch/PVA ratio increased. Composites with PVA as matrix material was not reported before.Keywords
This publication has 13 references indexed in Scilit:
- Determination of thermal stability and activation energy of polyvinyl alcohol–cassava starch blendsCarbohydrate Polymers, 2011
- Preparation and characterization of polypropylene–wheat straw–clay compositesComposites Science and Technology, 2010
- Poly(vinyl chloride)–wood flour press mould composites: The influence of raw materials on performance propertiesComposites Part A: Applied Science and Manufacturing, 2009
- Rice straw as a new resource for some beneficial usesCarbohydrate Polymers, 2009
- Nanoclay reinforced HDPE as a matrix for wood-plastic compositesComposites Science and Technology, 2008
- Studies on the Water Absorption Properties of Short Hemp—Glass Fiber Hybrid Polypropylene CompositesJournal of Composite Materials, 2007
- Interface Modification and Mechanical Properties of Natural Fiber-Polyolefin Composite ProductsJournal of Reinforced Plastics and Composites, 2005
- Properties of thermoplastic composites based on wheat‐straw lignocellulosic fillersJournal of Applied Polymer Science, 2004
- Effects of vacuum, mold temperature and cooling rate on mechanical properties of press consolidated glass fiber/PET compositeComposites Part A: Applied Science and Manufacturing, 2002
- Natural fiber polymer composites: A reviewAdvances in Polymer Technology, 1999