Synthesis of Inertially Compensated Variable-Speed Cams
Authors:
- 1 September 2003
- journal article
- Published by Wiley in Journal of Mechanical Design
- Vol. 125 (3) , 593-601
Abstract
Traditionally, cam-follower systems are designed by assuming a constant camshaft speed. Nevertheless, all cam-follower systems, especially high-speed systems, exhibit some camshaft speed fluctuation (despite the presence of a flywheel) which causes the follower motions to be inaccurate. This paper therefore proposes a novel design procedure that explicitly takes into account the camshaft speed variation. The design procedure assumes that (i) the cam-follower system is conservative and (ii) all forces are inertial. The design procedure is based on a single design choice, i.e., the amount of camshaft speed variation, and yields (i) cams that compensate for the inertial dynamics for any period of motion and (ii) a camshaft flywheel whose (small) inertia is independent of the period of motion. A design example shows that the cams designed in this way offer the following advantages, even for non-conservative, non-purely inertial cam-follower systems: (i) more accurate camshaft motion despite a smaller flywheel, (ii) lower motor torques, (iii) more accurate follower motions, with fewer undesired harmonics, and (iv) a camshaft motion spectrum that is easily and robustly predictable.Keywords
This publication has 18 references indexed in Scilit:
- Designing Dynamically Compensated and Robust Cam Profiles With Bernstein-Be´zier Harmonic CurvesJournal of Mechanical Design, 1998
- Use of Noncircular Gears to Reduce Torque and Speed Fluctuations in Rotating ShaftsJournal of Mechanical Design, 1997
- Minimizing Residual Vibrations in High-Speed Cam-Follower Systems Over a Range of SpeedsJournal of Mechanical Design, 1995
- The Design of High-Speed Dwell-Rise-Dwell Cams Using Linear Quadratic Optimal Control TheoryJournal of Mechanical Design, 1994
- Optimization of Cam Mechanisms1991
- Application of Optimal Control Theory to the Synthesis of High-Speed Cam-Follower Systems. Part 1: Optimality CriterionJournal of Mechanical Design, 1983
- Effect of Flexibility of Driving Shaft on the Dynamic Behavior of a Cam MechanismJournal of Engineering for Industry, 1975
- Dynamic Synthesis of Cams Using Finite Trigonometric SeriesJournal of Engineering for Industry, 1975
- Polydyne Cam Mechanisms for Typehead PositioningJournal of Engineering for Industry, 1972
- Minimum Vibration Cam ProfilesJournal of Mechanical Engineering Science, 1968