X-Band Tunable Frequency Selective Surface Using MEMS Capacitive Loads
Authors:
- 29 December 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 63 (3) , 1014-1021
Abstract
A tunable frequency selective surface (FSS) based on slotted ground is presented. Tuning of the resonance frequency is achieved by using a metallic MEMS bridge over the slot. The bridge acts as a capacitive load, increasing the equivalent capacitance, and so decreasing the resonance frequency. Electromagnetic and electromechanical simulations are performed to investigate the designed FSS. S-parameter measurements of the FSS unit cell are performed in a waveguide simulator, showing more than 1.7 GHz frequency shift in the X-band, achieved by using only one MEMS bridge. A measured bandwidth of 400 MHz at the resonance frequency of 9.59 GHz is achieved. The designed MEMS bridge benefits from an unconventional method of using SU-8 as the sacrificial layer, resulting in low loss at high frequencies (3.2 dB loss at the resonance frequency of 9.59 GHz). Devices with different heights of the MEMS bridge were fabricated to study the variation in the resonance frequency. The MEMS bridge was tested at fixed heights. Simulated and measured results show excellent agreement. An FSS array is designed based on the FSS unit cell results. The design procedure to maximize the quality factor and controllable frequency range, and improve the radiation characteristics of the FSS array is discussed. Further simulations are performed to examine the performance of the FSS array with regards to grating lobes, oblique incidence and tunability.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
This publication has 15 references indexed in Scilit:
- Development of a MEMS-enabled frequency selective surface2014
- Frequency selective surface implemented using MEM-switched ground plane slots2012
- Comparison of two different simulation methods for the design of reflect-arrays2010
- Magnetic MEMS Reconfigurable Frequency-Selective SurfacesJournal of Microelectromechanical Systems, 2006
- Switchable Low-Loss RF MEMS$Ka$-Band Frequency-Selective SurfaceIEEE Transactions on Microwave Theory and Techniques, 2004
- Varactor tunable frequency selective absorberElectronics Letters, 2003
- Reconfigurable FSS response from two layers of slotteddipole arraysElectronics Letters, 1996
- Frequency selective surfaces on biased ferrite substratesElectronics Letters, 1994
- Tunable frequency selective surface using liquidsubstratesElectronics Letters, 1994
- Equivalent-circuit formulas for metal grid reflectors at a dielectric boundaryApplied Optics, 1985