Failures Analysis of E-Glass Fibre reinforced pipes in Oil and Gas Industry: A Review
Authors:
Open Access
- 7 July 2017
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 217 (1) , 012004
Abstract
A comprehensive review is conducted on the failures in the field of manufacturing and installation of E-glass fiber reinforced pipes (GFRP).Some of the failures which are mainly encountered after the installation of E-Glass fiber reinforced pipes are the for nation of air bubbles in between the polyester resin layer and the surface film, dispersion of moisture in between the tubing outer and inner layers after installation, heat released in between the layers of E-glass fiber reinforced pipes due to exothermic reaction which in turn results in the formation of cracks on the surface of the pipe. The recent findings and challenges performed in conducting research regarding the deterioration caused in glass fiber reinforced pipes are highlighted and each type of failure that was identified was illustrated with an appropriate high resolution photograph .Performing creep resistance and fatigue analysis are new aspects which are still requited to be analyzed which ave not been stated in the literature which are nominated.Keywords
This publication has 23 references indexed in Scilit:
- Effect of water immersion on the interlaminar and flexural performance of low cost liquid resin infused carbon fabric compositesComposites Part B: Engineering, 2012
- Failure analysis of (±55°)3 filament wound composite pipes with an inclined surface crack under static internal pressureComposite Structures, 2010
- Fatigue damage in composite cylindersPolymer Composites, 2009
- Analysis of multi-layered filament-wound composite pipes under combined internal pressure and thermomechanical loading with thermal variationsComposite Structures, 2009
- Water Absorption Behavior and Its Influence on Properties of GRP PipeJournal of Composite Materials, 2007
- Thermoplastic Composite Cylinders for Underwater ApplicationsJournal of Thermoplastic Composite Materials, 2005
- The effect of cyclic hygrothermal conditions on the stresses near the surface of a thick composite pipeComposites Science and Technology, 2002
- Nano-indentation and nano-scratch of polymer/glass interfaces. II: model of interphases in water aged composite materialsPolymer, 2001
- Effect of reinforcement and solvent content on moisture absorption in epoxy composite materialsComposites Part A: Applied Science and Manufacturing, 2000
- Tensile failure of filament-wound pipes under long-term creep loading: A probabilistic analysisComposites Science and Technology, 1997