On the dimensional accuracy of deep drawing products by hydroforming processes
Authors:
- S. YossifonSYS. Yossifon
- J. TiroshJTJ. Tirosh
- 1 January 1991
- journal article
- Published by Elsevier in International Journal of Mechanical Sciences
- Vol. 33 (4) , 279-295
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- The Maximum Drawing Ratio in Hydroforming ProcessesJournal of Engineering for Industry, 1990
- On the Permissible Fluid-Pressure Path in Hydroforming Deep Drawing Processes—Analysis of Failures and ExperimentsJournal of Engineering for Industry, 1988
- High speed deep drawing of hardening and rate sensitive solids with small interfacial frictionJournal of the Mechanics and Physics of Solids, 1987
- Rupture instability in hydroforming deep-drawing processInternational Journal of Mechanical Sciences, 1985
- On suppression of plastic buckling in hydroforming processesInternational Journal of Mechanical Sciences, 1984
- The buckling of annular plates in relation to the deep-drawing processInternational Journal of Mechanical Sciences, 1982
- Plastic instability conditions when deep-drawing into a high pressure mediumInternational Journal of Mechanical Sciences, 1973
- Plastic instability conditions in the deep-drawing of a circular blank of sheet metalInternational Journal of Mechanical Sciences, 1972
- On the Swift cup testJournal of the Mechanics and Physics of Solids, 1966
- The Effect of Anisotropy and Work-Hardening Characteristics on the Stress and Strain Distribution in Deep DrawingJournal of Engineering for Industry, 1966