The effect of Zn interlayer on microstructure and mechanical performance during TIG overlap welding-brazing of Al to Ti
Open Access
- 23 January 2020
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (2) , 026514
Abstract
Tungsten inert gas welding-brazing technology was investigated to achieve the sound joining of Al-Ti alloys with the addition of Zn interlayer. Experiment results show that the Zn interlayer was beneficial to enhance the wettability of weld metal on Ti alloy substrate and improve the weld appearance. With low heat input, a Zn rich layer was observed near the brazing zone. As the heat input increased, TiAl3 phase was generated in fusion area and the morphology of interfacial brazing layer changed from lamellar to serrate. With the welding current increased to 85A, the micro hardness of fusion area increased and presented a great fluctuation owing to the excessive formation of TiAl3 phase. Under the optimal welding current of 75A, the sound Al-Ti weldment with the maximum tensile strength of 175MPa was obtained. Eventually, the improvement mechanism of wettability was investigated.Keywords
Funding Information
- Science and technology research support project of Chongqing Education Commission (GZTG201614)
This publication has 29 references indexed in Scilit:
- TIG welding-brazing of Ti6Al4V and Al5052 in overlap configuration with assistance of zinc foilJournal of Materials Processing Technology, 2018
- Microstructure and mechanical properties of high-energy shot-peened Mg/Ti weldmentsScience and Technology of Welding and Joining, 2018
- A new method of hybrid friction stir welding assisted by friction surfacing for joining dissimilar Ti/Al alloyMaterials Letters, 2017
- Effect of high energy shot peening on the microstructure and mechanical properties of Mg/Ti jointsJournal of Alloys and Compounds, 2017
- Vacuum brazing high Nb-containing TiAl alloy to Ti60 alloy using Ti-28Ni eutectic brazing alloyJournal of Alloys and Compounds, 2017
- Effects of processing variables and heat treatments on Al/Ti-6Al-4V interface microstructure of bimetal clad-plate fabricated via a novel route employing friction stir lap weldingJournal of Alloys and Compounds, 2016
- Influence of Zn Coating on Interfacial Reactions and Mechanical Properties During Laser Welding-Brazing of Mg to SteelMetallurgical and Materials Transactions A, 2012
- Infrared brazing of Ti50Al50 and Ti–6Al–4V using two Ti-based filler metalsIntermetallics, 2008
- Formation process of the bonding joint in Ti/Al diffusion bondingMaterials Science and Engineering: A, 2008
- Microstructure characteristics in the interface zone of Ti/Al diffusion bondingMaterials Letters, 2002