Microstructure of additive layer manufactured Ti–6Al–4V after exceptional post heat treatments
- 1 August 2012
- journal article
- research article
- Published by Elsevier in Materials Letters
- Vol. 81, 84-87
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- Morphology, microstructure, and hardness of titanium (Ti-6Al-4V) blocks deposited by wire-feed additive layer manufacturing (ALM)Materials Science and Engineering: A, 2012
- Mechanical properties of additive manufactured titanium (Ti–6Al–4V) blocks deposited by a solid-state laser and wireMaterials & Design (1980-2015), 2011
- Deposition of Ti–6Al–4V using laser and wire, part I: Microstructural properties of single beadsSurface and Coatings Technology, 2011
- Wire based additive layer manufacturing: Comparison of microstructure and mechanical properties of Ti–6Al–4V components fabricated by laser-beam deposition and shaped metal depositionJournal of Materials Processing Technology, 2011
- The Origin of Microstructural Diversity, Texture, and Mechanical Properties in Electron Beam Melted Ti-6Al-4VMetallurgical and Materials Transactions A, 2010
- Texture and Crystal Orientation in Ti-6Al-4V Builds Fabricated by Shaped Metal DepositionMetallurgical and Materials Transactions A, 2010
- A study of the microstructural evolution during selective laser melting of Ti–6Al–4VActa Materialia, 2010
- Quasi-static and dynamic deformation behavior of Ti–6Al–4V alloy containing fine α2-Ti3Al precipitatesMaterials Science and Engineering: A, 2004
- Microstructural evolution of a Ti–6Al–4V alloy during β-phase processing: experimental and simulative investigationsMaterials Science and Engineering: A, 2004
- The laser additive manufacture of Ti-6Al-4VJOM, 2001