Cavitation Erosion and Jet Impingement Erosion Behavior of the NiTi Coating Produced by Air Plasma Spraying
Open Access
Abstract
Cavitation erosion and jet impingement erosion can result in a great loss of materials. NiTi alloy is a very promising candidate to acquire cavitation erosion resistance and jet impingement erosion resistance because of its superelasticity. Due to the high cost and poor workability of NiTi alloy, many people tried to overcome such drawbacks by preparing NiTi coatings on the basis of deteriorating the good properties as little as possible. From the aspect of the application of NiTi coating, the erosion resistance should be evaluated comprehensively. One of these evaluations involves the comparison of cavitation erosion resistance and jet impingement erosion resistance of NiTi. This evaluation has not been made thus far. Thus, in this study, the NiTi coating was prepared by air plasma spraying (APS) using pre-alloyed NiTi powder. Its microstructure, chemical composition and phase transformation were identified. Cavitation erosion behavior and jet impingement erosion behavior of the as-sprayed NiTi coating were compared. The results showed that the coating exhibited better jet impingement erosion resistance than cavitation erosion resistance. This was attributed to the oxides, impurities, cracks and pores that existed in the coating, whose effects on deteriorating the cavitation erosion were far greater than those worsening the jet impingement erosion.Keywords
This publication has 37 references indexed in Scilit:
- Cavitation erosion behavior of HVOF CaviTec coatingsWear, 2017
- Enhancing the erosion-corrosion resistance of steel through friction stir processingWear, 2017
- Cavitation damage: Theory and measurements – A reviewWear, 2017
- Cavitation-resistant NiTi coatings produced by low-pressure plasma spraying (LPPS)Wear, 2015
- Wear behaviour of martensitic NiTi shape memory alloy under ball-on-disk sliding testsTribology International, 2013
- Investigation of erosion–corrosion mechanisms of UNS S31603 using FIB and TEMTribology International, 2012
- Mapping erosion–corrosion of carbon steel in oil–water solutions: Effects of velocity and applied potentialWear, 2012
- Erosion–corrosion behavior of nano-particle-reinforced Ni matrix composite alloying layer by duplex surface treatment in aqueous slurry environmentCorrosion Science, 2009
- Erosion–corrosion interactions and their effect on marine and offshore materialsWear, 2006
- Cavitation erosion of plasma-sprayed NiTi coatingsWear, 2006