Measuring Permeability of Rigid Materials by a Beam‐Bending Method: V, Isotropic Rectangular Plates of Cement Paste
- 1 October 2004
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 87 (10) , 1927-1931
Abstract
Beam bending is an excellent method for measuring low permeabilities (≤10 −18 m 2 ) in homogeneous materials, because it is fast, requires no high pressure, and provides a concurrent measurement of the modulus of the material. The method was previously analyzed and substantiated for cylindrical or square beams. Recently, the analysis was extended to include isotropic and transversely isotropic rectangular beams. In this paper, the analysis is applied to measurements performed on cement paste, and it is shown that the solution for isotropic rectangular beams accounts for changes in the hydrodynamic behavior caused by changing the aspect ratio of the sample. The permeability and elastic modulus results are verified through comparison to previous measurements on cylindrical beams.Keywords
This publication has 6 references indexed in Scilit:
- Measuring permeability and stress relaxation of young cement paste by beam bendingCement and Concrete Research, 2003
- Measuring Permeability of Rigid Materials by a Beam‐Bending Method: III, Cement PasteJournal of the American Ceramic Society, 2002
- Measuring Permeability of Rigid Materials by a Beam‐Bending Method: I, TheoryJournal of the American Ceramic Society, 2000
- Measuring Permeability of Rigid Materials by a Beam‐Bending Method: II, Porous GlassJournal of the American Ceramic Society, 2000
- Bending of gel beams: method for characterizing elastic properties and permeabilityJournal of Non-Crystalline Solids, 1992
- A Sequential Simplex Program for Solving Minimization ProblemsJournal of Quality Technology, 1974