Dry Film Resist Laminated Microfluidic System for Electrical Impedance Measurements
Open Access
- 29 May 2021
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 12 (6) , 632
Abstract
In micro-electrical-mechanical systems (MEMS), thick structures with high aspect ratios are often required. Dry film photoresist (DFR) in various thicknesses can be easily laminated and patterned using standard UV lithography. Here, we present a three-level DFR lamination process of SUEX for a microfluidic chip with embedded, vertically arranged microelectrodes for electrical impedance measurements. To trap and fix the object under test to the electrodes, an aperture is formed in the center of the ring-shaped electrodes in combination with a microfluidic suction channel underneath. In a proof-of-concept, the setup is characterized by electrical impedance measurements with polystyrene and ZrO2 spheres. The electrical impedance is most sensitive at approximately 2 kHz, and its magnitudes reveal around 200% higher values when a sphere is trapped. The magnitude values depend on the sizes of the spheres. Electrical equivalent circuits are applied to simulate the experimental results with a close match.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (DFG, German Research Foundation) (SCHN 587/24-1 and FL 1033/2-1)
This publication has 42 references indexed in Scilit:
- A dry film technology for the manufacturing of 3-D multi-layered microstructures and buried channels for lab-on-chipMicrosystem Technologies, 2018
- Optimization and application of dry film photoresist for rapid fabrication of high-aspect-ratio microfluidic devicesMicrofluidics and Nanofluidics, 2016
- High-resolution permanent photoresist laminate TMMF for sealed microfluidic structures in biological applicationsJournal of Micromechanics and Microengineering, 2011
- A “dry and wet hybrid” lithography technique for multilevel replication templates: Applications to microfluidic neuron culture and two-phase global mixingBiomicrofluidics, 2011
- Dry film microchips for miniaturised separationsElectrophoresis, 2009
- A full-wafer fabrication process for glass microfluidic chips with integrated electroplated electrodes by direct bonding of dry film resistJournal of Micromechanics and Microengineering, 2009
- Microfluidic channel fabrication in dry film resist for production and prototyping of hybrid chipsLab on a Chip, 2004
- Electroplating moulds using dry film thick negative photoresistJournal of Micromechanics and Microengineering, 2003
- Buried microchannels in photopolymer for delivering of solutions to neurons in a networkSensors and Actuators B: Chemical, 1998
- Low-cost technology for multilayer electroplated parts using laminated dry film resistSensors and Actuators A: Physical, 1996