Laser‐Activated Selective Electroless Plating on 3D Structures via Additive Manufacturing for Customized Electronics
Authors:
- 2 August 2023
- journal article
- research article
- Published by Wiley in Advanced Materials Technologies
- Vol. 8 (18)
Abstract
This work proposes a facile and economical hybrid additive manufacturing (HAM)technology combining fused deposition modeling (FDM) 3D printing and laser‐activated selective electroless plating (ELP) for fabricating full functional end‐use 3D customized electronics. A functional acrylonitrile butadiene styrene (ABS) filament doped with dicopper hydroxide phosphate (Cu2(OH)PO4) catalysts is developed for FDM 3D printing. The 3D printed structure is selectively laser‐activated to generate CuI plating seeds on the ABS surface and then electrolessly plated. The poor surface finish, especially the layer lines, is an intrinsic defect of extrusion 3D printing, which not only affected the fabrication quality of the 3D substrates but also the electrical performance of the attached circuitry. Herein, a chemical polishing process based on acetone vapor is explored and characterized to significantly improve the surface quality and thereby the electrical performance of the attached copper layer. In this way, highly conductive metallic circuitry can be freeformly deposited and patterned on the 3D structure which is extremely attractive for customized 3D electronics. To show the application potential of this technology, a 3D conformal 555 timer astable oscillator circuit board and a hot‐wire flowmeter are developed as demonstrators.Keywords
Funding Information
- National Natural Science Foundation of China (61974025, 61504024, 62174027)
- Fundamental Research Funds for the Central Universities
This publication has 33 references indexed in Scilit:
- Binuclear Copper Complex Ink as a Seed for Electroless Copper Plating Yielding >70% Bulk Conductivity on 3D Printed PolymersAdvanced Materials Interfaces, 2018
- A Rapid Photopatterning Method for Selective Plating of 2D and 3D Microcircuitry on PolyetherimideAdvanced Functional Materials, 2017
- Fabricating Metallic Circuit Patterns on Polymer Substrates through Laser and Selective MetallizationACS Applied Materials & Interfaces, 2016
- Multiprocess 3D printing for increasing component functionalityScience, 2016
- Development of a Precision Surface Polishing System for Parts Fabricated by Fused Deposition ModelingMaterials and Manufacturing Processes, 2015
- On Surface Finish and Dimensional Accuracy of FDM Parts after Cold Vapor TreatmentMaterials and Manufacturing Processes, 2015
- Quantitative analysis of a chemical treatment to reduce roughness of parts fabricated using fused deposition modelingCIRP Annals, 2010
- A fast and flexible method for manufacturing 3D molded interconnect devices by the use of a rapid prototyping technologyPhysics Procedia, 2010
- Experimental study aiming to enhance the surface finish of fused deposition modeled partsCIRP Annals, 2009
- Vibrational spectrum of the acetone-water complex: a matrix isolation FTIR and theoretical studyThe Journal of Physical Chemistry, 1993