A Novel Interleaved Tri-State Boost Converter With Lower Ripple and Improved Dynamic Response
- 17 November 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 65 (7) , 5456-5465
Abstract
In this paper, the design and development of a novel interleaved tri-state boost converter (ITBC), which produces lower ripple and exhibits better dynamic response, is discussed. Boost converters are frequently connected in parallel and operate in an interleaving mode for the reduction of ripple content in source current and in output voltage. In this way, interleaved boost converter (IBC) is conceived, which improves the power handling capabilities and increases the overall system rating. It also has the advantage of reduction of the ripple content in source current and output voltage, but when control-to-output transfer function of IBC is derived under continuous conduction mode of operation, then a right-half-plane (RHP) zero appears in the transfer function. Due to the presence of RHP zero, IBC has nonminimum phase problem, which deteriorates the dynamic performance. The tri-state boost converter (TBC) is the best choice for RHP zero elimination, but due to the extra freewheeling mode, ripple content will also be increased. The proposed converter is a parallel combination of two TBC and operates in an interleaving mode. Therefore, the proposed converter has both of the advantages of TBC and IBC. The performance analyses of ITBC, TBC, and IBC have been studied based on simulation and experimental results. From the comparative analysis, it is observed that ITBC is performed better than other two converters. The ripple comparisons between three converters have also been done. It is found that the ripple content in ITBC is slightly greater than IBC but is less than TBC.Keywords
This publication has 17 references indexed in Scilit:
- Development of an Improved Tristate Buck–Boost Converter With Optimized Type-3 ControllerIEEE Journal of Emerging and Selected Topics in Power Electronics, 2017
- Design and fabrication of closed loop Two-Phase Interleaved Boost Converter with Type-III controller2016
- An Improved Interleaved Boost Converter With PSO-Based Optimal Type-III ControllerIEEE Journal of Emerging and Selected Topics in Power Electronics, 2016
- Design and implementation of type‐II and type‐III controller for DC–DC switched‐mode boost converter by using K ‐factor approach and optimisation techniquesIET Power Electronics, 2016
- Design and implementation of type-III controller in tri state boost converter2015
- Analysis of the Interleaved Isolated Boost Converter With Coupled InductorsIEEE Transactions on Industrial Electronics, 2014
- Optimized Power Stage Design of Low Source Current Ripple Fourth-Order Boost DC–DC Converter: A PSO ApproachIEEE Transactions on Industrial Electronics, 2014
- High Step-Up High-Efficiency Interleaved Converter With Voltage Multiplier Module for Renewable Energy SystemIEEE Transactions on Industrial Electronics, 2013
- Modeling and Control Design of the Interleaved Double Dual Boost ConverterIEEE Transactions on Industrial Electronics, 2012
- Small-signal analysis of multiphase interleaved boost converter with coupled inductorsIEE Proceedings - Electric Power Applications, 2005