Multifunctional Nanoadditive in Water Based Drilling Fluid for Improving Shale Stability
Authors:
- 6 December 2015
- conference paper
- Published by Society of Petroleum Engineers (SPE)
Abstract
Wellbore stability and formation damage are of great interest and significance in drilling industry. It is estimated, each year, millions of dollars are lost due to wellbore instability problems which are resulting from exposure of shale to drilling muds. The main objective of this research activity is to improve shale inhibition and wellbore stability by using Silica nanoparticles in mud formulation. Furthermore, it is also intended to use this nanoadditive as a multifunctional mud additive to decrease fluid loss, improve lubricity, avoid shale swelling and modify rheological properties. In order to achieve these objectives, experimental procedures have been planned in the following sequences; A) Different concentrations of Silica nanoparticles are used in conducting experiments in order to determine the nanoparticles concentration range that yields the optimum shale inhibition. B) Further experiments are conducted on the evaluation of rheological properties and fluid loss via API standard methods. C) Lubricity and shale swelling tests are performed via relevant standards. D) Overall evaluation of laboratory-prepared water based drilling fluid is performed and the results are presented and compared with the blank samples. In conclusion, according to the acquired results including nanoadditives in drilling fluid and comparing them with blank samples, it was found that the most economical and effective concentration of nanoparticles is below 1% w/v, which lead to an acceptable shale inhibition effects by plugging the nanosized pores. These effects are analyzed and reported graphically. Various charts and figures show the enhancement in rheological properties such as yield point by adding small amount of nanoadditive in comparison with ordinary vicosifiers in drilling fluids. The most significant achievement in this research is the cost effectiveness of the nanoadditive. Not only can we improve mud performance with a lower cost in comparison with previously used drilling additives, but also by further modifications, these additives can replace the ordinary drilling additives. Needless to say that such change has a considerable reduction in drilling fluids costs. Several works have accomplished in relation with applying Silica nanoparticles in drilling fluid formulation and approximately in all of these works, only higher concentrations of nanoparticles (more than 10%wt) can be applicable in the shadow of surfactants and ultrasonication methods for sufficient dispersion. The striking feature of this research is the consuming of nanoparticles in lower concentrations (maximum 1% w/v) and without the assistance of surfactants.Keywords
This publication has 9 references indexed in Scilit:
- Effect of silica nanoparticles on clay swelling and aqueous stability of nanoparticle dispersionsJournal of Nanoparticle Research, 2013
- A New Family of Nanoparticle Based Drilling Fluids2012
- Preliminary Test Results of Nano-based Drilling Fluids for Oil and Gas Field Application2011
- Minimizing Water Invasion in Shale Using Nanoparticles2009
- On the physical and chemical stability of shalesJournal of Petroleum Science and Engineering, 2003
- The Impact of Mud Infiltration on Wellbore Stability in Fractured Rock Masses2002
- Shale Stability: Drilling Fluid Interaction and Shale Strength1999
- Control of Shale Swelling Pressures Using Inhibitive Water-Base Muds1998
- Water-Based Glycol Drilling Muds: Shale Inhibition Mechanisms1994