Machinability studies on 17-4 PH stainless steel under cryogenic cooling environment
- 9 May 2017
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 32 (15) , 1775-1788
Abstract
Under higher cutting conditions, machining of 17-4 precipitation hardenable stainless steel (PH SS) is a difficult task due to the high cutting temperatures as well as accumulation of chips at the machining zone, which causes tool damage and impairment of machined surface finish. Cryogenic machining is an efficient, eco-friendly manufacturing process. In the current work, cutting temperature, tool wear (flank wear (Vb) and rake wear), chip morphology, and surface integrity (surface topography, surface finish (Ra), white layer thickness (WLT)) were considered as investigative machinability characteristics under the cryogenic (liquid nitrogen), minimum quantity lubrication (MQL), wet and dry environments at varying cutting velocities while machining 17-4 PH SS. The results show that the maximum cutting temperature drop found in cryogenic machining was 72%, 62%, and 61%, respectively, in contrast to dry, wet, and MQL machining conditions. Similarly, the maximum tool wear reduction was found to be 60%, 55%, and 50% in cryogenic machining over the dry, wet, and MQL machining conditions, respectively. Among all the machining environments, better surface integrity was obtained by cryogenic machining, which could produce the functionally superior products.Keywords
This publication has 27 references indexed in Scilit:
- Experimental investigation on the feasibility of dry and cryogenic machining as sustainable strategies when turning Ti6Al4V produced by Additive ManufacturingJournal of Cleaner Production, 2017
- Application of sustainable techniques in metal cutting for enhanced machinability: a reviewJournal of Cleaner Production, 2015
- On Applicability of Multilayer Coated Tool in Dry Machining of Aerospace Grade Stainless SteelMaterials and Manufacturing Processes, 2015
- Progressive tool-wear in machining of room-temperature austenitic NiTi alloys: The influence of cooling/lubricating, melting, and heat treatment conditionsJournal of Materials Processing Technology, 2015
- Cutting Speed Dependent Microstructure and Transformation Behavior of NiTi Alloy in Dry and Cryogenic MachiningJournal of Materials Engineering and Performance, 2014
- Environmentally conscious machining of difficult-to-machine materials with regard to cutting fluidsInternational Journal of Machine Tools and Manufacture, 2012
- Advanced Modeling and Optimization of Manufacturing Processes2011
- Transitioning to sustainable production – part II: evaluation of sustainable machining technologiesJournal of Cleaner Production, 2010
- Micro-flood (MF) technology for sustainable manufacturing operations that are coolant less and occupationally friendlyJournal of Cleaner Production, 2007
- Activated gas nitriding of 17-4 PH stainless steelSurface and Coatings Technology, 2006