Absorption of gaseous toluene in aqueous solutions of some kinds of fluorocarbon surfactant
Authors:
Open Access
- 14 October 2014
- journal article
- research article
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 65 (1) , 90-98
Abstract
A self-designed device was applied to treat a simulated exhaust gas loaded with toluene by aqueous solutions of five kinds of fluorocarbon surfactant (FS-3100, FS-22, FSN-100, FSO-100 and FSG) under the controlled laboratory conditions. The simulated exhaust gas is generated by a mixture of clean air and toluene vapor, and its toluene concentration can be controlled by changing the volume ratio of the inlet air to the vapor. Two mass transfer methods: liquid-liquid transfer and gas-liquid transfer, were compared for their toluene saturation capacities of these absorbent solutions, and it was found that more toluene was dissolved by the liquid-liquid transfer than by the gas-liquid transfer. According to the saturation capacities of these absorbent solutions and their Henry’s Constants, FSO-100 is the best absorbent to treat the simulated exhaust gas and was selected for further experiments. The FSO-100 absorbent solution with a concentration of 0.1 % shows an efficient absorption to the simulated exhaust gas, with a toluene saturation capacity of 4.2 mg/g. Heating distillation (90- 95 oC) is highly efficient to recover toluene from the FSO-100 absorbent solution as well as regenerate it. A toluene recovery of about 85 % was achieved. The regenerated absorption solution can keep its initial toluene absorption capacity during the reuse. Implications: There is a lack of information on fluorocarbon surfactants to be used for removing volatile organic compounds (VOCs) of industrial exhaust gases. This research investigated five kinds of fluorocarbon surfactant with different chemical structures as absorbents to treat a simulated exhaust gas loaded with toluene, and made a comparison between their toluene saturation capacities. The research revealed that FSO-100 (an ethoxylated nonionic fluorosurfactant) presents the best performance in trapping toluene, and heating distillation is feasible to recover toluene and regenerate the absorbent solution. The knowledge gained in this research provides a theoretical basis for selecting an appropriate fluorocarbon surfactant and preparing its aqueous solution to treat industrial exhaust gases loaded with toluene.Keywords
This publication has 32 references indexed in Scilit:
- Solubilization Absorption of Toluene Vapor by Formation of Oil-in Water Microemulsions with Cation SurfactantsSeparation Science and Technology, 2010
- Absorption and desorption of gaseous toluene by an absorbent microcapsules columnJournal of Hazardous Materials, 2010
- Absorption of a volatile organic compound by a jet loop reactor with circulation of a surfactant solution: Performance evaluationJournal of Hazardous Materials, 2008
- Highly fluoroalkylated amphiphilic triazoles: Regioselective synthesis and evaluation of physicochemical propertiesJournal of Fluorine Chemistry, 2005
- Recovery of VOCs from high‐volume, low‐VOC‐concentration air streamsAIChE Journal, 2001
- Removal of Volatile Organic Compounds from polluted airJournal of Loss Prevention in the Process Industries, 2000
- Kinetic Aspects of Surfactant Solubilization of Soil-Bound Polycyclic Aromatic HydrocarbonsEnvironmental Science & Technology, 1996
- Henry's Law Constant for Selected Volatile Organic Compounds in High-Boiling OilsJournal of Chemical & Engineering Data, 1996
- Absorption of Odorous Molecules in Aqueous Solutions of Polyethylene GlycolEnvironmental Technology, 1995
- Absorption process for the removal of organic solvents from exhaust airChemical Engineering & Technology, 1989