Influence of Deposition Parameters on Hardness Properties of InconelTM 718 Processed by Laser Powder Bed Fusion for Space Applications
Open Access
- 1 February 2023
- journal article
- research article
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 7 (1) , 36
Abstract
InconelTM 718 is widely used for commercial application in aerospace industry and additive manufacturing process allows for versatile design and manufacturing opportunities. In the present research, the results of a wide experimental campaign run on additive manufactured InconelTM 718 specimens obtained with different processing parameters are presented. In particular, the influence of process parameters (for both vertical and horizontal planes with respect to the building direction) on the hardness properties are investigated. A further investigation is performed on the optimal hardness testing procedure for additive manufacturing. The research is extended to as-built and heat-treated specimens. The new insight gained is that the orientation of the printing direction with respect to indentation direction can be responsible for scattering in hardness measurements and indentation size effect. As-built specimens show a strong anisotropy for in-plane and growth directions and an increment of hardness with respect to increasing energy density. The difference between hardness value with respect to the energy density and the measurements scattering are reduced by the heat treatment. A careful handling of hardness data is required when dealing with additive manufactured materials.Keywords
This publication has 47 references indexed in Scilit:
- Site specific control of crystallographic grain orientation through electron beam additive manufacturingMaterials Science and Technology, 2015
- Rationalization of Microstructure Heterogeneity in INCONEL 718 Builds Made by the Direct Laser Additive Manufacturing ProcessMetallurgical and Materials Transactions A, 2014
- On the Prediction of Strength from Hardness for Copper AlloysJournal of Materials, 2013
- Microstructures and mechanical behavior of Inconel 718 fabricated by selective laser meltingActa Materialia, 2012
- General relationship between strength and hardnessMaterials Science and Engineering: A, 2011
- Microstructure and mechanical properties of nickel based superalloy IN718 produced by rapid prototyping with electron beam melting (EBM)Materials Science and Technology, 2011
- Correlation of Yield Strength and Tensile Strength with Hardness for SteelsJournal of Materials Engineering and Performance, 2008
- Indentation size effect in metallic materials: Correcting for the size of the plastic zoneScripta Materialia, 2005
- Selective laser melting of iron-based powderJournal of Materials Processing Technology, 2004
- On the Tensile Strength and Hardness Relation for MetalsJournal of Materials Engineering and Performance, 2001