In Situ Toughened Silicon Carbide with Al‐B‐C Additions
Authors:
- 1 February 1996
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 79 (2) , 461-469
Abstract
“In situ toughened” silicon carbides, containing Al, B, and C additives, were prepared by hot pressing. Densification, phase transformations, and microstructural development were described. The microstructures, secondary phases, and grain boundaries were characterized using a range of analytical techniques including TEM, SEM, AES, and XRD. The modulus of rupture was determined from fourpoint bend tests, while the fracture toughness was derived either from bend tests of beam‐shaped samples with a controlled surface flaw, or from standard disk‐shaped compact‐tension specimens precracked in cyclic fatigue. The R‐curve behavior of an in situ toughened SiC was also examined. A steady‐state toughness over 9 MPa·m1/2 was recorded for the silicon carbide prepared with minimal additives under optimum processing conditions. This increase in fracture toughness, more than a factor of three compared to that of a commercial SiC, was achieved while maintaining a bend strength of 650 MPa. The mechanical properties were found to be related to a microstructure in which platelike grain development had been promoted and where crack bridging by intact grains was a principal source of toughening.Keywords
This publication has 26 references indexed in Scilit:
- Cyclic fatigue in monolithic alumina: mechanisms for crack advance promoted by frictional wear of grain bridgesJournal of Materials Science, 1995
- Toughness Properties of a Silicon Carbide with an in Situ Induced Heterogeneous Grain StructureJournal of the American Ceramic Society, 1994
- In Situ‐Toughened Silicon CarbideJournal of the American Ceramic Society, 1994
- Mechanical properties of β-SiC pressureless sintered with Al2O3 additionsActa Metallurgica et Materialia, 1994
- A frictional-wear mechanism for fatigue-crack growth in grain bridging ceramicsActa Metallurgica et Materialia, 1993
- Fracture of Brittle Solids1993
- Sintering of in‐Situ Synthesized Sic–TiB 2 Composites with Improved Fracture ToughnessJournal of the American Ceramic Society, 1992
- The quantitative calculation of SiC polytypes from measurements of X-ray diffraction peak intensitiesJournal of Materials Science, 1979
- Fracture from Controlled Surface Flaws1979
- Stress Analysis of Cracks1965