A GENERALIZED FATIGUE LIMIT CRITERION AND A UNIFIED THEORY OF LOW‐CYCLE FATIGUE DAMAGE
Authors:
- 1 October 1996
- journal article
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 19 (10) , 1207-1219
Abstract
Abstract— A generalized fatigue limit criterion for multiaxial stress state conditions of isotropic materials is presented. This criterion includes four material parameters and uses two invariants of stress amplitudes and furthermore two invariants of mean stresses. It is shown that the fatigue criteria of Sines and Crossland are particular cases of the formulated criterion. Practical recommendations for the use of different fatigue limit criteria are established. Theoretical predictions are compared with experimental data. Finally a continuum damage mechanics theory for low cycle fatigue of isotropic materials is proposed. This theory describes simultaneously the influence of the stress amplitude and the mean stress on the fatigue damage suffered by materials. The proposed theory is based on four material parameters. Special damage theories with a smaller number of material parameters are obtained. Practical recommendations for the use of these fatigue damage theories are presented.Keywords
This publication has 9 references indexed in Scilit:
- Ermüdungsfestigkeit1995
- Fatigue design criteria for ceramic components under cyclic loadingInternational Journal of Fatigue, 1994
- Low Cycle Fatigue and Cycle Dependent Creep with Continuum Damage MechanicsInternational Journal of Damage Mechanics, 1992
- Mechanics of Solid Materials1990
- Evaluation of mean stress effect on fatigue life by use of damage parametersInternational Journal of Fatigue, 1986
- Fatigue Criteria Under Combined Stresses or StrainsJournal of Engineering Materials and Technology, 1981
- Fatigue failure of metals1978
- A Theory for Fatigue Failure under Multiaxial Stress-Strain ConditionsProceedings of the Institution of Mechanical Engineers, 1973
- A Theory for the Effect of Mean Stress on Fatigue of Metals Under Combined Torsion and Axial Load or BendingJournal of Engineering for Industry, 1959