Dynamic properties of additively manufactured tantalum
Authors:
Open Access
- 9 September 2021
- journal article
- research article
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 250, 05011
Abstract
In this study a series of gas gun plate impact experiments have been conducted on samples of wire arc AM tantalum to investigate the high strain rate behaviour of the material, including tensile failure (spall) mechanisms. Conventionally processed tantalum was fielded alongside the AM material to provide a direct comparison under identical loading conditions. In-situ velocimetry data was supported by pre-shock characterisation of the samples to supply information on the initial material microstructure, and to link these features to the observed differences in dynamic behaviour. Additional post-shock analysis of the damaged region in the samples provided further insight into the failure process.Keywords
This publication has 9 references indexed in Scilit:
- Revealing relationships between porosity, microstructure and mechanical properties of laser powder bed fusion 316L stainless steel through heat treatmentMaterials & Design, 2020
- Grain refinement in an unalloyed tantalum structure by combining Wire+Arc additive manufacturing and vertical cold rollingAdditive Manufacturing, 2020
- Microstructure, hardness and mechanical properties of two different unalloyed tantalum wires deposited via wire + arc additive manufactureInternational Journal of Refractory Metals and Hard Materials, 2019
- Structure/property (constitutive and spallation response) of additively manufactured 316L stainless steelActa Materialia, 2017
- Compressive and Tensile Stress–Strain Responses of Additively Manufactured (AM) 304L Stainless Steel at High Strain RatesJournal of Dynamic Behavior of Materials, 2017
- Spall fracture in additive manufactured Ti-6Al-4VJournal of Applied Physics, 2016
- Wire + Arc Additive ManufacturingMaterials Science and Technology, 2016
- Comparison of the microstructures and mechanical properties of Ti–6Al–4V fabricated by selective laser melting and electron beam meltingMaterials & Design, 2016
- Anisotropic tensile behavior of Ti–6Al–4V components fabricated with directed energy deposition additive manufacturingActa Materialia, 2015