Formation and mechanical properties of Cu–Hf–Ti bulk glassy alloys [Article Retracted]
Authors:
Open Access
- 1 October 2001
- journal article
- retracted article
- Published by Springer Nature in Journal of Materials Research
- Vol. 16 (10) , 2836-2844
Abstract
High-strength Cu-based bulk glassy alloys were formed in the Cu–Hf–Ti system by the copper mold casting and melt clamp forging methods. The maximum diameter is 4 mm for the Cu60Hf25Ti15 alloy. The substitution of Hf in the Cu60Hf40 alloy by Ti causes an increase in the glass-forming ability (GFA). As the Ti content increases, the glass transition temperature (Tg) decreases, while the crystallization temperature (Tx) shows a maximum at 5% Ti and then decreases, resulting in a maximum supercooled liquid region ΔTx (= Tx − Tg) of 78 K at 5% Ti. The liquidus temperature (T1) has a minimum of 1172 K around 20% Ti, and hence, a maximum Tg//T1 of 0.62 is obtained at 20% Ti. The high GFA was obtained at the compositions with high Tg/T1. The bulk glassy alloy exhibits tensile fracture strength of 2130 MPa, compressive fracture strength of 2160 MPa, and compressive plastic elongation of 0.8 to 1.6%. The new Cu-based bulk glassy alloys with high Tg/T1 above 0.60, high fracture strength above 2100 MPa, and distinct plastic elongation are encouraging for future development as a new type of bulk glassy alloy that can be used for structural materials.Keywords
This publication has 27 references indexed in Scilit:
- Dynamic crystallization process in a supercooled liquid region of Cu40Ti30Ni15Zr10Sn5 amorphous alloyJournal of Non-Crystalline Solids, 2000
- Bulk amorphous alloys with soft and hard magnetic propertiesMaterials Science and Engineering: A, 1997
- Preparation of Bulk Glassy Pd40Ni10Cu30P20 Alloy of 40 mm in Diameter by Water QuenchingMaterials Transactions, JIM, 1996
- High Strength Bulk Amorphous Alloys with Low Critical Cooling Rates (Overview)Materials Transactions, JIM, 1995
- Fe-Based Ferromagnetic Glassy Alloys with Wide Supercooled Liquid RegionMaterials Transactions, JIM, 1995
- Ti-based amorphous alloys with a wide supercooled liquid regionMaterials Letters, 1994
- A highly processable metallic glass: Zr41.2Ti13.8Cu12.5Ni10.0Be22.5Applied Physics Letters, 1993
- Mg–Cu–Y Amorphous Alloys with High Mechanical Strengths Produced by a Metallic Mold Casting MethodMaterials Transactions, JIM, 1991
- Zr–Al–Ni Amorphous Alloys with High Glass Transition Temperature and Significant Supercooled Liquid RegionMaterials Transactions, JIM, 1990
- Glassy metalsReports on Progress in Physics, 1980