Comparison of the effects of different loading locations on stresses transferred to straight and angled implant-supported zirconia frameworks: a finite element method study
Authors:
Open Access
- 9 April 2015
- journal article
- research article
- Published by Taylor & Francis in Biotechnology & Biotechnological Equipment
- Vol. 29 (4) , 766-772
Abstract
The paper presents three-dimensional (3D) finite element models of straight and angled implants and their zirconium-based superstructures. The key objective was to compare the influence of different loading conditions on the stress distribution of straight and angled implants and the zirconia frameworks. 3D finite element straight- and angled-implant models of a mandibular section of bone with missing second molars and their zirconium-based superstructures were used. The straight and angled implants were 4.7 × 13-mm screw-type dental implant systems. Total loads of 300 N were applied in a vertical direction and in an oblique (30° to the vertical) direction buccolingually. Maximum and minimum von Mises stress values of the titanium structures (abutment and implant body) and zirconia frameworks were calculated. When the two groups were examined, the highest stress value was in the zirconia framework of the angled implant-supported model with an oblique loading force (731.46 MPa). The lowest stress values were concentrated in the straight implant-supported model. Thus, the stress values in the angled implant-supported crown were higher than those in the straight implant-supported model. Stress values with oblique loading forces were higher than the values with vertical loading forces. The highest stress value in the zirconia framework was similar to the ultimate strength of the zirconia.Keywords
This publication has 19 references indexed in Scilit:
- Three-dimensional finite element analysis of effect of prosthetic materials and short implant biomechanics on D4 bone under immediate loadingJournal of Dental Implants, 2012
- The influence of implant diameter and length on stress distribution of osseointegrated implants related to crestal bone geometry: A three-dimensional finite element analysisThe Journal of Prosthetic Dentistry, 2008
- Effect of hybrid layer on stress distribution in a premolar tooth restored with composite or ceramic inlay: An FEM studyJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005
- Three-dimensional finite-element analysis of functional stresses in different bone locations produced by implants placed in the maxillary posterior region of the sinus floorThe Journal of Prosthetic Dentistry, 2005
- Long‐term evaluation of non‐submerged ITI implants. Part 1: 8‐year life table analysis of a prospective multi‐center study with 2359 implants.Clinical Oral Implants Research, 1997
- Three-dimensional finite element analysis of stress-distribution around single tooth implants as a function of bony support, prosthesis type, and loading during functionThe Journal of Prosthetic Dentistry, 1996
- The placement of angled implants in the edentulous maxillae for the use of overdenturesThe Journal of Prosthetic Dentistry, 1991
- Limits of human bite strengthThe Journal of Prosthetic Dentistry, 1986
- A 15-year study of osseointegrated implants in the treatment of the edentulous jawInternational Journal of Oral Surgery, 1981
- Masticatory function—a review of the literatureJournal of Oral Rehabilitation, 1975