A Design of Wireless Power Receiver With Gate Charge Recycled Dual-Mode Active Rectifier and Step-Down Converter With 88.2% System Efficiency for Power Management IC
- 8 September 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 38 (1) , 1348-1360
Abstract
This article presents a power management integrated circuit for a wireless power receiver unit. A dual-mode high-efficiency active rectifier design is based on alliance for wireless power (A4WP) and wireless power consortium (WPC) standards. A gate charge recycling technique is proposed in the dual-mode active rectifier so that the current generated by the switching of the high side gate driver can be recycled to the rectifier output voltage in order to enhance efficiency. A step-down dc–dc converter with a proposed bootstrap circuit and dynamic pull-up resistor gate driver circuit is designed. The chip is implemented in a 0.18-μm bipolar-CMOS double-diffused metal-oxide-semiconductor process. The total die area, including the pad, is 2.64 mm × 2.6 mm. The measurement results show that the active rectifier achieves peak power conversion efficiency (PCE) of 94.7% and generates an output voltage of 7.68 V in WPC mode and 9.1 V with 93.4% efficiency in A4WPC mode. The input voltage varies from 10 V P-P –12 V P-P . Similarly, the step-down dc–dc converter obtains a peak PCE of 93.2% at a load current of 500 mA while producing an output voltage of 5 V. The overall system efficiency at A4WP and WPC mode are 86.7% and 88.2%, respectively.Keywords
Funding Information
- Technology Innovation Program
- Industrial Strategic Technology Development Program (20011971)
- Ministry of Trade, Industry and Energy
- Ministry of Science and ICT, South Korea (IITP-2022-2020-0-01821)
- Institute for Information & Communications Technology Planning & Evaluation
This publication has 31 references indexed in Scilit:
- Adaptive On/Off Delay-Compensated Active Rectifiers for Wireless Power Transfer SystemsIEEE Journal of Solid-State Circuits, 2016
- A Design of a Wireless Power Receiving Unit With a High-Efficiency 6.78-MHz Active Rectifier Using Shared DLLs for Magnetic-Resonant A4 WP ApplicationsIEEE Transactions on Power Electronics, 2015
- Efficiency and Optimal Loads Analysis for Multiple-Receiver Wireless Power Transfer SystemsIEEE Transactions on Microwave Theory and Techniques, 2015
- A 10/30 MHz Fast Reference-Tracking Buck Converter With DDA-Based Type-III CompensatorIEEE Journal of Solid-State Circuits, 2014
- A Maximum Efficiency Point Tracking Control Scheme for Wireless Power Transfer Systems Using Magnetic Resonant CouplingIEEE Transactions on Power Electronics, 2014
- 94.6% peak efficiency DCM buck converter with fast adaptive dead-time control2013
- A 13.56 MHz CMOS Active Rectifier With Switched-Offset and Compensated Biasing for Biomedical Wireless Power Transfer SystemsIEEE Transactions on Biomedical Circuits and Systems, 2013
- A Synchronous Buck Converter Using a New Predictive Analog Dead-Time Control Circuit to Improve EfficiencyCanadian Journal of Electrical and Computer Engineering, 2013
- A 3.0-W wireless power receiver circuit with 75-% overall efficiency2012
- Improvement of Light-Load Efficiency Using Width-Switching Scheme for CMOS TransistorsIEEE Power Electronics Letters, 2005