Power Scaling of Ytterbium-doped Fiber Superfluorescent Sources
Authors:
- 18 June 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Quantum Electronics
- Vol. 13 (3) , 580-587
Abstract
Power scaling of ytterbium-doped fiber superfluorescent sources based on single-stage and two-stage cladding-pumped fiber configurations is reported. For the single-stage configuration, a novel fiber-end termination scheme was employed to suppress laser oscillation in combination with a simple all-fiber scheme for achieving a predominantly single-ended output. The fiber was cladding-pumped by a diode stack at 976 nm and yielded ~62 W of single-ended amplified spontaneous emission output for 119 W of launched pump power, limited by the onset of parasitic lasing. At pump powers in excess of 40 W, the slope efficiency with respect to the launched pump power was 67%. The emission spectrum spanned the wavelength range from 1030 to 1100 nm and the bandwidth (FWHM) was 12 nm. Scaling to higher power levels was demonstrated using a two-stage cladding-pumped fiber configuration comprising of a low-power fiber superfluorescent seed source and a high-power amplifier. The two-stage source yielded 122 W of amplified spontaneous emission output (limited by available pump power) in a beam with M2 ap 2.1. The slope efficiency for the amplifier with respect to the launched pump power was 77%. The prospects for further improvement in performance and output power are considered.Keywords
This publication has 15 references indexed in Scilit:
- High-power ultrafast fiber laser systemsIEEE Journal of Selected Topics in Quantum Electronics, 2006
- Dual-stage superfluorescent fiber source with 1.16-W output power centered at 1561nmOptical Engineering, 2006
- Single-frequency, single-mode, plane-polarized ytterbium-doped fiber master oscillator power amplifier source with 264 W of output powerOptics Letters, 2005
- 321 W average power, 1 GHz, 20 ps, 1060 nm pulsed fiber MOPA source2005
- High return loss at the end face of fiberApplied Optics, 2001
- High-power, broad-band 1550 nm light source by tandem combination of a superluminescent diode and an Er-doped fiber amplifierIEEE Photonics Technology Letters, 1992
- Modeling of three-level laser superfluorescent fiber sources1991
- Analysis of a 1060-nm Nd:SiO/sub 2/ superfluorescent fiber laserJournal of Lightwave Technology, 1989
- Fabrication of low-loss optical fibres containing rare-earth ionsElectronics Letters, 1985
- Saturation Effects in High-Gain LasersJournal of Applied Physics, 1965