Numerical evaluation of the thermal performance of a solar air heater equipped with two different types of baffles
- 8 January 2020
- journal article
- research article
- Published by Wiley in Heat Transfer
- Vol. 49 (3) , 1149-1169
Abstract
In the present study, the effect of utilizing two different types of baffles in the channel of the solar air heater is investigated numerically. The studied baffles include angled rectangular baffles and angled V‐shaped baffles, which are mounted on the bottom and top walls of the duct, respectively. Both considered baffles were evaluated separately which the studied parameter in each section was the angular position of baffles. Finally, the best‐obtained results of both sections were compared to each other. The results indicated that in the rectangular model by comparison between 90° model and no baffle, it was found that the pressure drop and average Nusselt number increase 316.67% and 148.15%, respectively at Reynolds number (Re) = 2000. Also, in V‐shaped angled baffles, the thermal efficiency of β = 90°, 60°, 45°, and 30° are 27%, 18%, 13% higher than no baffle channel at Re = 2000, respectively. Furthermore, at low Re (about Re below 300), utilizing baffles into the channel had no effect on the thermal efficiency of the system compared to the no baffle channel. However, at high Re, it was found that the highest thermal efficiency occurred in the model of rectangular baffles with an angle of 90°.Keywords
This publication has 62 references indexed in Scilit:
- Heat and fluid flow in entrance region of a channel with staggered bafflesEnergy Conversion and Management, 2006
- Review of passive heat transfer augmentation techniquesProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2004
- Use of porous baffles to enhance heat transfer in a rectangular channelInternational Journal of Heat and Mass Transfer, 2003
- Comparison between laminar and turbulent heat transfer in a stationary square duct with transverse or angled rib turbulatorsInternational Journal of Heat and Mass Transfer, 2001
- THREE-DIMENSIONAL HEAT TRANSFER IN A CHANNEL WITH A BAFFLE IN THE ENTRANCE REGIONNumerical Heat Transfer, Part A: Applications, 1997
- HEAT TRANSFER IN A THREE-DIMENSIONAL CHANNEL WITH BAFFLESNumerical Heat Transfer, Part A: Applications, 1996
- Augmented Heat Transfer in Square Channels With Parallel, Crossed, and V-Shaped Angled RibsJournal of Heat Transfer, 1991
- Numerical Prediction of Flow and Heat Transfer in a Parallel Plate Channel With Staggered FinsJournal of Heat Transfer, 1987
- Conjugate heat transfer in a channel with staggered ribsInternational Journal of Heat and Mass Transfer, 1985
- Fully Developed Flow and Heat Transfer in Ducts Having Streamwise-Periodic Variations of Cross-Sectional AreaJournal of Heat Transfer, 1977