Structure‐property relationships for styrene‐diene thermoplastic elastomers
Authors:
- 1 January 1969
- journal article
- research article
- Published by Wiley in Journal of Polymer Science Part C: Polymer Symposia
- Vol. 26 (1) , 99-115
Abstract
A study has been carried out on block polymers of the A‐B‐A type, the thermoplastic elastomers, where A represents polystyrene and B polybutadiene or polyisoprene. The objective was to relate the mechanical properties of these elastomers to their molecular architecture. For this purpose a series of styrene‐butadiene and styrene‐isoprene block polymers were synthesized by means of organolithium initiators, in which the block lengths of the polystyrene and polydiene were varied. It was found that the stress‐strain properties of styrene‐butadiene polymers are mainly dependent on the polystyrene content, regardless of the block sizes, and that the center, elastic block does not appear to behave as the “molecular weight between crosslinks” of these networks. However, the monodispersity of the chain length of these elastic blocks does appear to contribute substantially to higher tensile strengths. The polystyrene appears to be aggregated in small domains, of the order of several hundred angstrom units, and these undergo an irreversible deformation under stress, which is, however, completely recoverable above the Tg of the polystyrene. At high polystyrene contents (∼40%) these elastomers exhibit an irreversible yield point at very low elongations, and this is ascribed to the presence of a continuous phase of connected polystyrene domains, which can be re‐formed by raising the temperature above the Tg of the polystyrene. Although the stress‐strain curves are not affected by the thermal history of the sample, the tensile strength, especially at high styrene contents, is strongly dependent on “annealing” of any frozen stresses in the polystyrene phase. The useful range of block molecular weights is about 10,000–20,000 for polystyrene and 40,000–80,000, respectively, for polybutadiene. The lower limit is probably governed by the minimum polystyrene chain length required to insure the formation of a heterogeneous phase; while the upper limit is set by the high viscosity of both blocks, which might seriously hamper domain formation.Keywords
This publication has 11 references indexed in Scilit:
- Procedures for Homogeneous Anionic Polymerization.Journal of Research of the National Bureau of Standards Section A: Physics and Chemistry, 1966
- Viscoelastic Behavior of Segmented ElastomersTextile Research Journal, 1966
- Tailored heterogeneity indices in anionic polymerizationJournal of Polymer Science Part A-1: Polymer Chemistry, 1966
- A theory of the glass transitionJournal of Polymer Science Part B: Polymer Letters, 1963
- Homogeneous anionic polymerization. I. Molecular weights of polystyrene initiated by sodium naphthaleneJournal of Polymer Science Part A: General Papers, 1963
- Light-scattering and osmotic-pressure study on solutions of polystyrene of narrow molecular-weight distribution produced by anionic catalysisTransactions of the Faraday Society, 1961
- Isoprene polymerization by organometallic compounds. IIJournal of Polymer Science, 1959
- LIGHT-SCATTERING STUDIES OF COPOLYMERS: I. EFFECT OF HETEROGENEITY OF CHAIN COMPOSITION ON THE MOLECULAR WEIGHTCanadian Journal of Chemistry, 1958
- POLYMERIZATION INITIATED BY ELECTRON TRANSFER TO MONOMER. A NEW METHOD OF FORMATION OF BLOCK POLYMERS1Journal of the American Chemical Society, 1956
- The Synthesis and Applicability of Block and Graft CopolymersTextile Research Journal, 1953