A novel processing method for injection‐molded polyether–urethane scaffolds. Part 1: Processing
Authors:
- 20 October 2005
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 77B (1) , 65-72
Abstract
A large‐scale scaffold processing method with injection molding has been successfully developed. Water was used as afoaming agent for the new technique. NaCl was used as a porogen to achieve an open‐cell structure. Organic solvents, which are common foaming agents for polyurethane, where not used. Toxic remains in the polymer were therefore prevented. Pore size and porosity was adjustable through process parameters. A parameter study showed that an increase in injection pressure, plasticize speed, cylinder, and mold temperature raised the mean pore diameter. The porosity also could be mended by the cylinder and mold temperature, in addition to NaCl concentration. It was possible to produce scaffolds with a porosity of 64 ± 3%, a pore size distribution from 30–450 μm, and a mean pore diameter of 270 ± 90 μm. The interconnective pores were found to lie between 5 and 58 μm. © 2005 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 2006Keywords
This publication has 30 references indexed in Scilit:
- Supercritical carbon dioxide aided preparation of conductive polyurethane–polypyrrole compositesThe Journal of Supercritical Fluids, 2004
- The Design of Scaffolds for Use in Tissue Engineering. Part I. Traditional FactorsTissue Engineering, 2001
- Processing of Polyamide 11 with Supercritical Carbon DioxideIndustrial & Engineering Chemistry Research, 2001
- Formation of highly porous biodegradable scaffolds for tissue engineeringElectronic Journal of Biotechnology, 2000
- POLYMER SCAFFOLD PROCESSING2000
- Microporous, Resorbable Implants Produced by the CESP ProcessAdvanced Engineering Materials, 1999
- Design of Macroporous Biodegradable Polymer Scaffolds for Cell TransplantationMaterials Science Forum, 1997
- Novel approach to fabricate porous sponges of poly(d,l-lactic-co-glycolic acid) without the use of organic solventsBiomaterials, 1996
- Fabrication of biodegradable polymer scaffolds to engineer trabecular boneJournal of Biomaterials Science, Polymer Edition, 1996
- An accurate numerical solution for mass diffusion-induced bubble growth in viscous liquids containing limited dissolved gasInternational Journal of Heat and Mass Transfer, 1992