Structural Analysis on Planar Defects Formed in WC Platelets in Ti‐Doped WC–Co
Authors:
- 5 September 2006
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 89 (10) , 3229-3234
Abstract
Platelet‐reinforced WC–Co alloys are processed by liquid‐phase sintering from very fine‐grained WC powders in the presence of small amounts of TiC. Large and flat WC grains develop in the material. The microstructure of these platelets is investigated by high‐resolution electron microscopy in order to obtain information on their formation mechanism. Inside the grains, an extended defect parallel to the basal plane is observed. It can be described by a pair of stacking faults with a shear vector equal to 1/3 〈0‐110〉 occurring in two successive (0001) planes. At the level of the faults, the plane spacing is slightly reduced. The defect area is similar to a thin cubic layer about 0.5 nm thick at the interior of the platelet. The enhanced grain growth of the platelets is likely related to the presence of the defect area.Keywords
This publication has 15 references indexed in Scilit:
- Formation of Grain Boundaries in Liquid‐Phase‐Sintered WC–Co AlloysJournal of the American Ceramic Society, 2005
- Cr-rich layer at the WC/Co interface in Cr-doped WC–Co cermets: segregation or metastable carbide?Journal of Crystal Growth, 2004
- Accommodation of the Lattice Mismatch at the VCx-WC InterfaceInterface Science, 2004
- Characteristics and origin of clusters in submicron WC-Co cermetsPhilosophical Magazine, 2003
- On the formation of very large WC crystals during sintering of ultrafine WC–Co alloysInternational Journal of Refractory Metals and Hard Materials, 2002
- HRPACK: a software describing the elastic fields near dislocations and interfaces at atomic scaleUltramicroscopy, 1997
- EMS - a software package for electron diffraction analysis and HREM image simulation in materials scienceUltramicroscopy, 1987
- The defect structure of tungsten carbide in deformed tungsten carbide-cobalt compositesActa Metallurgica, 1982
- Room-temperature deformation mechanisms and the defect structure of tungsten carbideActa Metallurgica, 1981
- Constitution of ternary titanium-tungsten-carbon alloysJournal of the Less Common Metals, 1973