An Investigation of the Mechanical Characteristics of Four CAD-CAM Monolithic Zirconia Materials
Open Access
Abstract
Transparent CAD/CAM monolithic ceramics are increasingly used in dentistry due to their combination of high strength, esthetics, and durability, achieved through high yttria content and multilayered systems. This study evaluates the mechanical behavior of four widely used CAD/CAM ceramics, correlating their performance with microstructural characteristics. Bar-shaped specimens (n = 10 per material, for each test) of ZOLID® FX ML (ZF), IPS E.MAX® CAD (MC), E.MAX® ZIRCAD (ZM), and KAT-ANA® STML (KS) (all A2 shade) were prepared and sintered according to manufacturers’ protocols. Flexural strength and elastic modulus were measured using three-point bending, and Vickers hardness was determined separately. Statistical normality was confirmed with the Kolmogorov–Smirnov test. Flexural strength ranged from 252.8 ± 39.8 MPa (MC) to 547.6 ± 125.7 MPa (ZM), elastic modulus from 65.8 ± 6.5 GPa (MC) to 94.1 ± 5.8 GPa (KS), and hardness from 4.2 ± 0.2 GPa (MC) to 9.6 ± 0.6 GPa (ZF). High-elastic-modulus materials (KS, ZM) can better resist deformation under occlusal loads, improving long-term stability of posterior crowns, bridges, and implant-supported restorations. High hardness (ZF) provides superior wear resistance and preserves occlusal anatomy over time, making it suitable for thin-shell restorations and high-stress functional surfaces. Materials with lower modulus and hardness (MC) are more suitable for intra-coronal restorations or thin veneers where stress shielding and material compliance are advantageous. These findings support material selection based on mechanical demands, and further clinical studies are needed to confirm long-term performance.Keywords
Funding Information
- Jordan University of Science and Technology (20190375)
This publication has 33 references indexed in Scilit:
- Zirconia in fixed prosthodontics: a review of the literatureOdontology, 2024
- Layer characteristics in strength-gradient multilayered yttria-stabilized zirconiaDental Materials, 2023
- Microstructure, composition, and flexural strength of different layers within zirconia materials with strength gradientDental Materials, 2023
- Strength and reliability of zirconia fabricated by additive manufacturing technologyDental Materials, 2022
- Impact of different layers within a blank on mechanical properties of multi-layered zirconia ceramics before and after thermal agingDental Materials, 2022
- Optical properties of CAD-CAM monolithic systems compared: three multi-layered zirconia and one lithium disilicate systemHeliyon, 2021
- Strength and aging resistance of monolithic zirconia: an update to current knowledgeJapanese Dental Science Review, 2020
- Chairside CAD/CAM materials. Part 2: Flexural strength testingDental Materials, 2017
- Marginal and internal fit of pressed lithium disilicate partial crowns in vitro: A three-dimensional analysis of accuracy and reproducibilityDental Materials, 2012
- Brittleness index of machinable dental materials and its relation to the marginal chipping factorJournal of Dentistry, 2007