New control strategy in a square-wave inverter for low wattage metal halide lamp supply to avoid acoustic resonances
- 3 January 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 21 (1) , 243-253
Abstract
High intensity discharge (HID) lamps are the most suitable when both high light power levels and good color rendering are researched. Some remarkable theoretical advantages would be obtained if these kinds of lamps were driven with high frequency (HF) electronic ballasts. Nevertheless, at these frequencies, acoustic resonances (AR) phenomenon appears. Low wattage metal halide (MH) lamps are, among all HID lamps, the most affected by this phenomenon. To obtain lack of AR in HID lamps, lamp power frequency harmonics must have a lower amplitude than a certain threshold value, related to activation energy. An electronic ballast may be designed to guarantee power harmonics levels lower than this threshold level at nominal operation. Nevertheless, the equivalent resistance of HID lamps varies highly in starting and warm-up stages, as well as in the aging process. Therefore, the system must be designed to be adequate for the necessary "supplying conditions" for these load variations. In this paper, a new control strategy for a HF square-wave inverter is presented. This ballast keeps lamp power harmonics at low levels, regardless of the lamp equivalent load. The proposed ballast, along with the control strategy, is presented, as well as the built prototypes and experimental results carried out. From these experiments, it can be concluded that the proposed method supplies low wattage MH lamps with lack of acoustic resonances.Keywords
This publication has 10 references indexed in Scilit:
- Complete Low-Cost Two-Stage Electronic Ballast for 70-W High-Pressure Sodium Vapor Lamp Based on Current-Mode-Controlled Buck–Boost InverterIEEE Transactions on Industry Applications, 2005
- Evaluation of high-frequency sinusoidal waveform superposed with 3rd harmonic for stable operation of metal halide lamps2003
- The simplest electronic ballast for HID lamps2002
- White-noise modulation of high-frequency high-intensity discharge lamp ballasts2002
- A MHz electronic ballast for automotive-type HID lamps2002
- Electronic ballast for HID lamps with high frequency square waveform to avoid acoustic resonances2002
- Using solid-state over-voltage protection devices for high intensity discharge lamps ignition2002
- Stability study and control methods for small-wattage high-intensity-discharge (HID) lampsIEEE Transactions on Industry Applications, 2001
- A new high-frequency and high-efficiency electronic ballast for HID lamps: topology, analysis, design, and experimental results1999
- The High-Pressure Sodium Lamp1986