Process variations and the transient behavior of extruders
Authors:
- 1 December 2003
- journal article
- process systems-engineering
- Published by Wiley in AIChE Journal
- Vol. 49 (12) , 3150-3160
Abstract
To explain output fluctuation problems in extrusion, a transient model of material flow through an extruder is developed and used to study the transmission of external disturbances through the extruder. This model can be implemented for any extrusion geometry for which a pressure‐throughput model exists. Simulation results show that every extrusion process has a characteristic critical frequency. All disturbance frequencies above this critical value are damped out and the lower frequency components are transmitted through the process with little amplitude attenuation. These low frequency disturbances are of most concern since they are not damped by the extrusion process. Extrusion screw configurations are designed to satisfy steady‐state performance requirements, and nonsteady‐state performance is rarely considered. The findings indicate that a two pronged approach would be required combining screw design (passive control) to handle higher frequencies and closed‐loop control (active control) to detect and remove lower frequency disturbances.Keywords
This publication has 20 references indexed in Scilit:
- Behavior of fully filled regions in a non‐intermeshing twin‐screw extruderPolymer Engineering & Science, 2003
- A mechanism for extrusion instabilities in polymer meltsPolymer Engineering & Science, 1999
- A non-Newtonian model of flow in forward and backward pumping screw regions of a modular tangential counter-rotating twin-screw extruderJournal of Non-Newtonian Fluid Mechanics, 1990
- Non-Newtonian flow modelling in the screw regions of an intermeshing corotating twin screw extruderJournal of Non-Newtonian Fluid Mechanics, 1989
- A non-Newtonian model of flow in a kneading disc region of a modular intermeshing corotating twin screw extruderJournal of Non-Newtonian Fluid Mechanics, 1988
- A Simulation of the Effect of Formula and Feed Rate Variations on the Transient Behavior of Starved Extrusion ScrewsBiotechnology Progress, 1987
- On the dynamics and control of a plasticating extruderPolymer Engineering & Science, 1982
- A critical review of dynamic modeling and control of plasticating extrudersPolymer Engineering & Science, 1982
- THE USE OF KETAMINE HYDROCHLORIDE FOR ENDOTRACHEAL INTUBATION IN CATTLEAustralian Veterinary Journal, 1979
- Surging in screw extrudersPolymer, 1979