Analysis of the best roughness surface based on the bearing area curve theory
- 17 May 2021
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 236 (3) , 527-540
Abstract
An in-depth study of friction and wear requires analysis of the surface morphologies and contact status of friction pairs in mechanical systems. The bearing area curve is introduced for the calculation of wear, and combined with the concept of repositioning. The application of fast calculation of wear amount and improved three-dimensional characterization of a bearing area curve is achieved by this new method. The best roughness surface is used as the target surface to extract the target bearing area curve. The influence of microtexture parameters on the bearing area curve is studied to determine the optimal microtexture parameters. The test results show that a matching texture surface has a short run-in time and the lowest friction coefficient after stabilization among the surfaces studied herein, and the presence of a texture changes the wear mechanism from the original adhesive wear to abrasive wear and improves the tribological performance. The best texture parameters and laser process parameters are determined, which provide new ideas for the optimal design of surface topography.Keywords
Funding Information
- China Postdoctoral Science Foundation (2020M671354)
- National Natural Science Foundation of China (51575245 and 51679112)
- Six Talent Peak Selection and Training Program of Jiangsu (ZNYQC-002)
This publication has 13 references indexed in Scilit:
- Bi-Gaussian surface identification and reconstruction with revised autocorrelation functionsTribology International, 2017
- A technique to measure surface asperities plastic deformation and wear in rolling contactWear, 2016
- The measurement of wear using AFM and wear interpretation using a contact mechanics coupled wear modelWear, 2016
- Topography changes observation during running-in of rolling contactsWear, 2014
- The effect of random surface topography height on fretting in dry gross slip conditionsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2014
- Correlation between standard roughness parameters skewness and kurtosis and tribological behaviour of contact surfacesTribology International, 2012
- New cylinder liner surfaces for low oil consumptionTribology International, 2008
- Changes in the micro-geometry of a rolling contactTribology International, 2007
- Measurement of wear on asperity level using image-processing techniquesWear, 2005
- Assessment of engine liner wear from bearing area curvesWear, 2000