In Vitro Hydrolysis of Poly(l-lactide) Crystalline Residues as Extended-Chain Crystallites: II. Effects of Hydrolysis Temperature
Authors:
- 9 March 2004
- journal article
- research article
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 5 (3) , 1021-1028
Abstract
The effects of hydrolysis temperature on the hydrolysis behavior and mechanism of poly(l-lactide) crystalline residues or extended-chain crystallites were investigated in phosphate-buffered solution (50−97 °C), using gel permeation chromatography and differential scanning calorimetry (DSC). The hydrolysis of the crystalline residues proceeded from their surface composed of very short chains with a free end along the chain direction, irrespective of hydrolysis temperature, but the hydrolysis from their lateral surface could not be traced. The activation energy of hydrolysis for the crystalline residues (extended-chain crystallites) was evaluated to be 18.0 kcal mol-1 (75.2 kJ mol-1). The monotonic melting temperature (Tm) and crystallinity decreases occurred after their initial very small increases, excluding the monotonic crystallinity decrease at 97 °C with no initial increase. The Tm decrease reflects the decreased thickness of the crystalline residues. The equilibrium Tm of the crystalline residues (extended-chain crystallites) was estimated to be 464.5−464.9 K. The free energy values for the surface composed of very short chains with a free end, which are neighboring the air (or nitrogen during DSC scanning), were calculated to be 55.6−56.4 erg cm-2 for heat of fusion per unit mass = 135 J g-1. The obtained surface free energy values are significantly higher than that for the surface composed of folding chains, tie chains, and the chains with a free end, which are neighboring the same kind of amorphous chains (39.9 erg cm-2).Keywords
This publication has 13 references indexed in Scilit:
- Biodegradable polyesters for medical and ecological applicationsMacromolecular Rapid Communications, 2000
- Properties and morphology of poly( l -lactide) 4. Effects of structural parameters on long-term hydrolysis of poly( l -lactide) in phosphate-buffered solutionPolymer Degradation and Stability, 2000
- Determination of the Equilibrium Melting Temperature of Polymer Crystals: Linear and Nonlinear Hoffman−Weeks ExtrapolationsMacromolecules, 1998
- Blends of isotactic and atactic poly(lactide)s: 2. Molecular-weight effects of atactic component on crystallization and morphology of equimolar blends from the meltPolymer, 1996
- Blends of isotactic and atactic poly(lactide). I. Effects of mixing ratio of isomers on crystallization of blends from meltJournal of Applied Polymer Science, 1995
- Present and Future of PLA PolymersJournal of Macromolecular Science, Part A, 1995
- Properties and morphologies of poly(?-lactide): 1. Annealing condition effects on properties and morphologies of poly(?-lactide)Polymer, 1995
- Relationship between the lateral surface free energy .sigma. and the chain structure of melt-crystallized polymersMacromolecules, 1992
- Crystal structure, conformation and morphology of solution-spun poly(L-lactide) fibersMacromolecules, 1990
- Crystallization kinetics of poly(l-lactic acid)Polymer, 1983