Development of wrought precipitation strengthened IN939 superalloy
- 1 December 2012
- journal article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 28 (12) , 1470-1478
Abstract
The potential of cast IN939 superalloy to be converted to wrought alloy has been explored in the present work. For this objective, bars of cast alloy were rolled under different conditions and then subjected to various heat treatment cycles. The results indicated that the yield strength, ultimate tensile strength and ductility of the wrought IN939 alloy are superior to the cast version. The stress rupture properties of wrought IN939 superalloy are better than those of the widely used superalloys, such as Nimonic 90 and Waspaloy, and approach the alloy Nimonic 105 properties. This is very notable because Nimonic 105 contains ∼45 vol.- γ′ that is much greater than the volume fraction of those strengthening precipitates in the alloy IN939 (∼35). On the whole, the wrought form of this alloy has a high potential for manufacturing hot components to be used safely under aggressive turbine environment.Keywords
This publication has 43 references indexed in Scilit:
- Influence of Co content on stacking fault energy in Ni–Co base disk superalloysJournal of Materials Research, 2011
- Effect of Microstructure on High-Temperature Mechanical Behavior of Nickel-Base Superalloys for Turbine Disc ApplicationsAdvanced Materials Research, 2011
- Fatigue resistance of the grain size transition zone in a dual microstructure superalloy diskInternational Journal of Fatigue, 2011
- A Novel Strategy for the Design of Advanced Engineering Alloys—Strengthening Turbine Disk Superalloys via Twinning StructuresAdvanced Engineering Materials, 2010
- The effects of carbon content on the microstructure and elevated temperature tensile strength of a nickel-base superalloyMaterials Science and Engineering: A, 2010
- Microsegregation Induced Inhomogeneity of Coarsening of γ’ Precipitates in a Nickel-Based Single Crystal SuperalloyDefect and Diffusion Forum, 2010
- Strain Rate Effects and Hardening Mechanisms in Ni Base SuperalloysMaterials Science Forum, 2010
- Creep behavior of new kinds of Ni–Co-base superalloysMaterials Science and Engineering: A, 2009
- Strengthening via deformation twinning in a nickel alloyMaterials Science and Engineering: A, 2008
- Preparation of a (Ti,Nb,W)C particulate reinforced nickel-base superalloy via super-high temperature treatment of meltMaterials Letters, 2003