Numerical simulation of nanosecond laser drilling of 316L stainless steel: addition of laser focus and analysis of manufacturing process
Open Access
- 8 December 2023
- journal article
- research article
- Published by IOP Publishing in Modelling and Simulation in Materials Science and Engineering
- Vol. 32 (1) , 015009
Abstract
A two-dimensional model of nanosecond laser drilling 316L stainless steel was established with the consideration of laser focus, which was indeed different from the original two-phase flow model without laser focus, especially in the temperature field, velocity field, surface morphology and hole depth. Simulation and experiment of drilling holes with different laser repetition frequencies (100 kHz, 50 kHz and 20 kHz) were carried out. The results show that manufacturing process could divide into three stages: high-efficiency phase, stabilization stage and low-efficiency phase. Meanwhile, the limited number of pulses at 100 kHz, 50 kHz and 20 kHz were obtained, and the values were approximately 289, 367 and 492, respectively. More, the values at 10 kHz and 200 kHz obtained by modeling were very close to those calculated by the fitted equation. All the research provides theoretical, simulation and experimental basis for designing and optimizing parameters on laser surface manufacturing.Keywords
Funding Information
- National Nature Science Foundation of China (52175540)
- China Postdoctoral Science Foundation (2020M673382)
- Doctoral Research Fund of Shaanxi University of Science and Technology (2016BJ-78)
- Science and Technology Plan of Weiyang District, Xi’an City, Shaanxi Province (202116)
- Shaanxi Provincial College Youth Innovation Team Project (2019)
This publication has 36 references indexed in Scilit:
- A processing technology of grooves by picosecond ultrashort pulse laser in Ni alloy: Enhancing efficiency and qualityOptics & Laser Technology, 2019
- The Marangoni effect on microstructure properties and morphology of laser-treated Al-Fe alloy with single track by FEM: Varying the laser beam velocityInternational Journal of Heat and Mass Transfer, 2018
- Pulsed Nd:YAG laser beam drilling: A reviewOptics & Laser Technology, 2018
- Development of a simulation model to study tool loads in pcBN when machining AISI 316LThe International Journal of Advanced Manufacturing Technology, 2018
- Modeling and simulation on long pulse laser drilling processingInternational Journal of Heat and Mass Transfer, 2014
- Influence of surface wettability on the tribological properties of laser textured Co–Cr–Mo alloy in aqueous bovine serum albumin solutionApplied Surface Science, 2013
- FEM based simulation of the pulsed laser ablation process in nanosecond fieldsJournal of Mechanical Science and Technology, 2011
- Bone response to laser-induced micro- and nano-size titanium surface featuresNanomedicine: Nanotechnology, Biology and Medicine, 2011
- Friction and wear of MoS2 films on laser textured steel surfacesSurface and Coatings Technology, 2008
- Experimental and numerical modelling of the residual stresses induced in orthogonal cutting of AISI 316L steelInternational Journal of Machine Tools and Manufacture, 2006